Hello John!
Nice to get a report from the Shetland Islands too. Looking forward to see a
capture or two later. Thanks for logging the QRG and as the PSU and PA seem to
take the beating from the QRSS pretty well I may even leave it running
overnight if I can arrange a simple bed in the shack.
The antenna tuning is varying only slightly now as the wire swings in the gentle
breeze. From startup the tuning drifted and the antenna current was below what I
had yesterday. After I started QRSS3 operation things changed fast and then
stabilized. On top of that the antenna current has increased from 0.7 to 1.0 A.
There must have been some thin frost on the insulators initially that the RF has
melted, I have no other explanation for such rapid changes.
Best regards
Paul-Henrik
Quoting John P-G <[email protected]>:
> On Fri, 16 Jan 2009 21:28:07 +0200
> Paul-Henrik <[email protected]> wrote:
>
> > LF, Hello!
> >
> > Many thanks to all that have reported and suggested so far. I will
> > reply to you later. I'm busy setting up and perfecting things at the
> > moment :)
> >
> > New QRG as suggested by Jim: 136.35kHz
>
> Hello Paul-Henrik, LF
>
> I've been out of the shack all evening, until now, but set Spec Lab up
> to show the frequency in question earlier. I'll check the 5-minte
> captures later, but I can confirm visual ID of your callsign in QRSS,
> on a quick glance at the screen. I haven't had a chance to optimise
> Spec Lab on the new PC installation yet, so I'm going to experiment on
> your signal, if you leave it running....
>
> Cheers,
>
> John
> GM4SLV
>
>
>
|
