Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

LF: Re: 136kHz test from OH1LSQ

To: <[email protected]>
Subject: LF: Re: 136kHz test from OH1LSQ
From: "Markus Vester" <[email protected]>
Date: Fri, 16 Jan 2009 19:20:42 +0100
In-reply-to: <[email protected]>
References: <[email protected]>
Reply-to: [email protected]
Sender: [email protected]
Hello Paul-Henrik,

in my narrowband colour-DF spectrogram, I could see some activity from your 
direction starting at 16:18, and what looks like a 
continuous carrier slightly drifting from 136399.4 at 16:48 to about 136398.6 
Hz now. The signal is not strong enough here for CW or 
QRSS3, but would be perfectly readable with 30 second dots. I have temporarily 
set the lower grabber panel on 
http://freenet-homepage.de/df6nm/Grabber.htm to your frequency. If you like you 
could perhaps interrupt or slightly shift the 
carrier for a couple of minutes to provide unambiguous identification.

Good luck
Markus

Original Message ----- 
From: "Paul-Henrik" <[email protected]>
To: <[email protected]>
Sent: Friday, January 16, 2009 6:14 PM
Subject: Re: LF: 136kHz test from OH1LSQ


LF, transmitting now. CW on 136.40kHz.

Quoting Paul-Henrik <[email protected]>:

LF, Hello all!

I plan to run a test transmission on 136kHz during Friday, Saturday and Sunday
night. The setup is very preliminary/temporary and can not be left unattended
for longer periods. The unprotected ATU has to be brought indoors when not in
use. We expect cold dry weather for the weekend so it should survive while in
use. The estimated ERP based on tests made yesterday is only 20mW. This figure
does not include absorption in nearby objects.

Initially the transmission will be CW only but QRSS3 with CW ID will follow as
soon as I have the ON7YD keyer software and interface set up.

Antenna: Inverted-L 15m high with 35m horizontal wire. 20 radials 5-25m long,
half of them terminated in 0.5m deep earth rods. Rtot estimated to roughly
100ohms.
ATU: Variometer + large loading coil
TX: Keyed 1W 50ohm DDS signal generator feeding a pair of parallell 807's in
class AB1 trough a wideband 1:5 voltage stepup transformer providing 80Vp-p for
the control grids. Classic parallel tuned tank with adjustable coupling coil.
Power output is measured to 65W at 810V/150mA on the plates.

Unless I receive other suggestions for the QRG that will enable QRM-free QRSS
reception for interested stations the frequency will be 136.40kHz.

I can not receive on 136kHz during this test. I will inform when QRV/QRT.


Best regards

Paul-Henrik / OH1LSQ
Vaasa / KP03SD







<Prev in Thread] Current Thread [Next in Thread>