Yepp, I suppose so... I have the current version now.. Are you going to be home
today for a possible
daytime 160 meter run ??? I'll fire up the wire, if you are available to listen
( look ) for a bit..
Andy - KU4XR - EM75xr - Friendsville, TN. USA
Coordinates: N: 35º 43' 54" - W: 84º 3' 16"
http://lwca.org/grabbers/ku4xr/
http://www.myspace.com/beaconxr
http://ku4xr.webs.com
http://lwca.org/community/YaBB.pl
----- Original Message -----
From: Dexter McIntyre W4DEX <[email protected]>
To: [email protected]
Cc:
Sent: Tuesday, January 17, 2012 9:31 AM
Subject: Re: LF: Opera continuous changes
Think maybe that's why it's called a beta version? :)
Dex
Andy - KU4XR wrote:
> I am a bit perturbed myself...After being advised by the software that a new
> version was available,
> and I needed to download it, I did so... at around 9 pm my local time.. I
> thought I would give it a run on 160 meters, and had 1 station decode my
> signal, then nothing... I was running 40 watts to the Ae
> Something didn't seem right, but alas; I set it for 10 watts and went to bed
> only to get up, and see messages from other operators, telling me I needed to
> upgrade my software because the newversion
> didn't have OP3 in it..... In less than 11 hours, there was an incompatable
> upgrade....So for me, it turned out to be a completely wasted night of
> RF....Make changes; bench test it... Make more changes,
> bench test it some more.... Make sure that the next upgrade is " A Major One
> "
> Andy - KU4XR - EM75xr - Friendsville, TN. USA
> Coordinates: N: 35º 43' 54" - W: 84º 3' 16"
> http://lwca.org/grabbers/ku4xr/
> http://www.myspace.com/beaconxr
> http://ku4xr.webs.com
> http://lwca.org/community/YaBB.pl
>
>
> ----- Original Message -----
> From: Andy Talbot <[email protected]>
> To: o_p_e_r_a_ <[email protected]>; [email protected]
> Cc: Sent: Tuesday, January 17, 2012 4:12 AM
> Subject: LF: Opera continuous changes
>
> Just after I'd spent yesterday morning reprogramming the PIC code,
> re-writing the documentation and uploading to website for general
> access, the coding has been changed again.
>
> That's it. I'm not changing again until something has stabilised.
> The version posted only yesterday will now be removed, and not
> replaced for the time being.
> If you want an independent PIC based source, you're on your own
>
> If fundamental changes are going to me made like this, please at least
> warn us in advance.
>
> Andy
> www.g4jnt.com
>
>
>
|
