Re: LF: Ublox 8 question

[DK7FC <selberdenken@posteo.de>]

Chris,

Did you already contact the distributor? You know, Paul mentioned he has 
been in contact with him, so it seems to be possible to report about 
this problem and ask for advice directly.
73, Stefan

Am 07.01.2019 15:24, schrieb Chris Wilson:
> Hello Riccardo,
>
> There's definitely continuity from both output pins of the Ublox to
> the break out board pads, and it is a -T model. I have tried probing
> on the TP2 pin itself on the Ublox though with no joy. I'll try a full
> reset but I have a horrible feeling I have a faulty module :( Thanks
> for the advice :)
>
> Sunday, January 6, 2019, 2:54:15 PM, you wrote:
>
>
>
>    
> > Hi Chris,
> >      
>    
> > Well, only the NEO-M8T version has the TP2 functionality (readly available by 
> > default settings).
> >      
>    
> > -pin 3 (TIMEPULSE) of the Ublox module is often connected to a SMD
> > green LED (in series with a 1k0 resistor)
> >      
>    
> > -pin 1 (TP2/SAFEBOOT_N) is disconnected in my breakout board then I
> > soldered a wire directly on the GPS module's pin.
> >      
>    
> > Try to revert to default configuration (UBX - CFG page) and restore
> > again TIMEPULSE and TIMEPULSE2 settings (UBX - TP5 page).
> >      
>
>
>    
> > 73 de Riccardo IW4DXW
> >      
>
>
>