Hello Riccardo,
Thanks, a typo on my phone, I am always doing it, sorry, I was setting
1 MHz (mega) :) I'll try again but that sounds like I was doing it
correctly. Where should the probe ground be taken from please?
Friday, January 4, 2019, 6:21:37 PM, you wrote:
> Hi Chris, LF
> 1 mHz? Maybe 1 MHz: TP frequency must be in the range 0.25 Hz..10 MHz.
> In TP5 settings, toggle frequency and duty cycle flags then set
> 1000000 Hz and 50% d.c. in the f. locked fields. Press "send" button
> (in the lower part of cfg window).
> 73 de Riccardo IW4DXW
> Il giorno Ven 4 Gen 2019, 18:59 Chris Wilson <[email protected]> ha scritto:
>
> Hello LF'ers,
>
> My newly arrived Ublox 8 and breakout board has landed and I have had
> a very quick play with it and the Ublox UCentre software. I have set
> Time0 to give say a 1 mHz output in UBX / CFG / TP5 but scoping that
> through hole on the breakout board shows no output. I did instruct it
> to write to the device, and it sticks. What I am unsure about is where
> I should be taking the scope ground to, I used the shell of the USB
> connector socket. i am hoping it's not a fake or knackered... It came
> from the same place Stefan suggested and is the same model and same
> break out board he posted. Any idea if it's me being stupid again, and
> I have overlooked the obvious? Thanks.
>
>
>
> --
> Best regards,
> Chris mailto:[email protected]
>
>
>
--
Best regards,
Chris mailto:[email protected]
|
