Hello Riccardo,

There's definitely continuity from both output pins of the Ublox to
the break out board pads, and it is a -T model. I have tried probing
on the TP2 pin itself on the Ublox though with no joy. I'll try a full
reset but I have a horrible feeling I have a faulty module :( Thanks
for the advice :)

Sunday, January 6, 2019, 2:54:15 PM, you wrote:



> Hi Chris,


> Well, only the NEO-M8T version has the TP2 functionality (readly available by 
> default settings).


> -pin 3 (TIMEPULSE) of the Ublox module is often connected to a SMD
> green LED (in series with a 1k0 resistor)


> -pin 1 (TP2/SAFEBOOT_N) is disconnected in my breakout board then I
> soldered a wire directly on the GPS module's pin.


> Try to revert to default configuration (UBX - CFG page) and restore
> again TIMEPULSE and TIMEPULSE2 settings (UBX - TP5 page).




> 73 de Riccardo IW4DXW




-- 
Best regards,
 Chris                            mailto:[email protected]