Only M0DSZ decoded on 136
-----Original Message-----
From: [email protected]
Sent: Saturday, September 8, 2018 4:24 PM
To: [email protected]
Subject: LF: Re: 137 kHz WSPR-2 on a 900m long ground loop, this weekend
Nil to report at my QTH ur QRG 136 USB ie 137.425 RF FREQ
73 GL MAL/G3KEV
-----Original Message-----
From: DK7FC
Sent: Saturday, September 8, 2018 1:45 PM
To: [email protected]
Subject: Re: LF: RE: 137 kHz WSPR-2 on a 900m long ground loop, this weekend
RR,
Now, since 12 UTC the TX is in its final position and runs each 10
minutes. It will run for 24 hours or so.
So far the results are quite satisfying, for just 10 watts. With 100 W,
we could have a CW QSO in the groundwave range. Did you expect that?
Let's see what the night brings. Also the radiation pattern will be
interesting...
More reports from more stations are welcome :-)
73, Stefan
Am 08.09.2018 14:02, schrieb Clemens Paul:
Hi Genosse Stefan,
2018-09-08 11:56 DK7FC 0.137425 -17 -1 JN39 1 DL4RAJ
JN68kj 449 103
2018-09-08 11:56 DK7FC 0.137425 -11 0 JN39 1 DL0AO JN59vk
349 89
2018-09-08 11:08 DK7FC 0.137425 -10 0 JN39 1 DL0AO JN59vk
349 89
2018-09-08 11:56 DK7FC 0.137425 -22 0 JN39 1 PI4THT JO32kf
306 359
2018-09-08 11:08 DK7FC 0.137424 -22 0 JN39 1 PI4THT JO32kf
306 359
2018-09-08 11:56 DK7FC 0.137429 -18 0 JN39 1 DC0DX/RF
JO31lk 218 0
2018-09-08 11:56 DK7FC 0.137425 -26 0 JN39 1 DC5AL-R
JO31lk 218 0
73
Clemens
DL4RAJ
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of DK7FC
Sent: Saturday, September 8, 2018 1:18 PM
To: [email protected]
Subject: Re: LF: RE: 137 kHz WSPR-2 on a 900m long ground
loop, this weekend
Genossen!
I just matched the antenna and run some WSPR-2 transmissions
on 137.425 kHz.
I'm getting 260 mA antenna current at 10 W RF power. So the
overall loss
resistance should be 150 Ohm (the wire has about 30 Ohm). For
resonating
i need about 2.5 nF in series to the wire.
So the feed point impedance is Z = 150 Ohm + j450 Ohm, still
behaving as
a loop. Quite a comfortable managable impedance. I had to wind
an output
transformer on a "RIK20" core (Reichelt!), which works very well. The
secondary number of turns was unknown at the beginning ;-)
Regular transmissions will start in an hour or so.
73, Stefan
Am 08.09.2018 12:07, schrieb Clemens Paul:
Hi Genosse Stefan,
Will someone catch the signal at all? At least i'm already
asking for RX
stations!
I've just resonated my antenna aa inverted L on 137.5kHz (with 502µH)
and wil be ready to receive in WSPR-2 as soon as you start.
73
Clemens
DL4RAJ
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of DK7FC
Sent: Friday, September 7, 2018 1:49 PM
To: [email protected]
Subject: LF: 137 kHz WSPR-2 on a 900m long ground loop, this weekend
Genosse Roman, LF,
Yesterday i built a small LF PA providing 10 W at 50 Ohm. It
consumes 1
A at 12 VDC. I intend to run an over-night WSPR-2
transmission (20% TX
rate) on saturday night, using the ground loop or earth antenna in
JN39WI. The signal generator is a Raspberry Pi running on a
separate 7
Ah lead gel accu. The PA has its own 7 Ah accu. The PA can
switch from
2.5 W to 10 W :-)
Will someone catch the signal at all? At least i'm already
asking for RX
stations!
I'll carry some measuring equipment there, like my M0BMU LF tuning
meter, some Cs, a T106-2 and some wire, also a small ferrite core to
build a transformer if necessary.
What could the feed point impedance be? I have no idea! My modified
MFJ-259B covers LF but i expect it will be overloaded with strong
signals on the antenna, so i try to match the antenna with the
transmitter.
More soon :-)
73, Stefan
PS: Oh, i'm also going to connect two anti-parallel LEDs to
the antenna
to see if they shine. It is all a big game for old children!
Am 05.09.2018 23:54, schrieb Roman:
OK Stefan.
Try it to do. may be wonderful results.
Roman
Hello Roman,
Yes maybe i'll build a quick PA tomorrow for LF and will
transmit on LF
for 24 hours, each 10 minutes, WSPR-2. I have no idea at
all how this
antenna performs on 137 kHz. Is it still a loop or rather a
dipole or a
mixture? At least it has about the length of a full size
dipole for 137
kHz. I would TX at 10 W RF power only, so that a small accu
covers some
hours. But i'm not yet sure if i can find the time to do it
tomorrow.
73, Stefan
PS: If the antenna acts as a dipole, then it is beaming to
Russia directly.
Am 05.09.2018 21:42, schrieb Roman:
Congrts, Stefan!
We are follow by your success!
Listen, do you planning to operate 136 kHz, I hear, tell
me pse - do you planing try to TX with that ant on 477 kHz and 160M?
I will be interestin to hear about results.
73!
Roman
---
Diese E-Mail wurde von AVG auf Viren geprüft.
http://www.avg.com
|
