Andy,
WOLF interleaving hasn't changed since the very beginning. Markus has
pointed out the source code location -- Wolf Buscher's GUI is a
wrap-around for the core code created by Stewart Nelson.
As Warren suggests, the WOLF and WOLF_GUI programs have a method of
creating a file representing the 960 bits in the message. I have used
that in a small transmitter at my other QTH to send a static text giving
callsign and QTH. I simply brought the output file into the 8051 code as
a look-up table, and step through it with 100ms interrupts from a
divider chain.
For the original Stewart Nelson program, the following instructions were
given:
"If you have a BPSK-capable beacon which uses an EEPROM to store its
message, WOLF can generate a binary file suitable for programming the
device. This mode is activated by supplying a negative argument to the
'n' option:
C:\wolf>wolf -x "KK7KA RENO NV" -n -1
WOLF version 0.31
Wrote wolfx.bin, 961 bytes
The wolfx.bin file has one byte for each bit to be transmitted, followed
by a "reset" byte. The data is in the LSB (bit 0), and the reset
function is in bit 1. You may need to convert the .bin file to a .hex
for some programmers."
DL4YHF carried all of the command-line parameters into the GUI version.
If you call up his program with:
WOLF_GUI -x "W1TAG HOLDEN MA" -n -1
you will get a wolfx.bin file in that directory, which you can use for
beaconing.
If you want to change the message "on the fly," then work from the
DL4YHF version noted by Markus.
John, W1TAG
On 2/1/2016 12:18 PM, Andy Talbot wrote:
I'm contemplating writing some PIC code to encode WOLF (the software)
into a PIC to make a standalone beacon transmitter source. A generator
for the rate 1/6 32 constraint length convolutional code will fit into
a 16F628A chip without too much difficulty - I've already done it for
JT4 and WSPR; it just needs more parallel shift registers and less
message memory than those modes do.
Looking back though the archives of various progs written over the
years, I found one written back in 2010 that generates the bit pattern
for a WOLF message. So back then, must have been thinking of doing
something with WOLF but it never got beyond a basic coder. To be able
to write that software I must have had the original source code by John
/ team or Wolf (the operator!) for the mode, but can't find it.
Also have a bit of a conundrum - in that software I provided the option
for interleaving the final data or not, but don't know if the current
Wolf GUI software implements interleaving or not.
This is the interleaving code I wrote back then (PowerBasic language,
variables here are all long ints) but don't know if its currently
implemented in the latest versions
IF interlv THEN
tempj = j
SHIFT RIGHT tempj , 3
PTR = k * 80 + (j AND 7) * 10 + tempj + i * 2
ELSE
PTR = k * 80 + j + i * 16
END IF
outdata(PTR) = b
Is the WOLF source code available anywhere, and is interleaving
implemented?
Also, is there an option somewhere to generate a file or even a screen
showing of the output bit pattern?
Short of actually running WolfGUI with a test message, recording the
output and comparing it with my generated sequence for the same message
it's difficult to know if my software gives the right answers.
Andy G4JNT
|
