Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

Re: LF: Where to measure antenna current?

To: [email protected]
Subject: Re: LF: Where to measure antenna current?
From: John Rabson <[email protected]>
Date: Mon, 19 Oct 2015 18:45:16 +0200
Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=gmail.com; s=20120113; h=content-type:mime-version:subject:from:in-reply-to:date :content-transfer-encoding:message-id:references:to; bh=zO5y+oCSwN4j0O5XtmfdtvXBiXZsHvZswIB0cVoijSM=; b=X3/7RN2wzKd/AY7O06ZGrA949n0ovf+lv6jeVs4eI8OEYujP3mF30jWaHQcOvTdyrA PKpggOmtiPcC+XE1yBDCWPyNPcQc7ExM9dxj+E7+zwJnmxD+I6rrG5kRZATC8nCysr7T niNXCdFoEtUs7MT/STKfRnCMnJfPiEEh0t5OdK1BShqSZUrqFt3HDOeTObWIg2/rWJpK O3H09u0CS7bX3BIV3MG0U8rDj3yWOnWZXLE3ybKJOY901w5qoC7E0Zgnr7KpXwI5pu2c HY3RXzm0Dl4nX6vzz8AGhavIpECO4iX74NMsJisGBlHjCQrv0FRnAb1fsCV2DQj0ydqn q1/Q==
In-reply-to: <[email protected]>
References: <[email protected]>
Reply-to: [email protected]
Sender: [email protected]
Chris,

The arrangement I have here comprises a 5A FSD RF ammeter between the 
transmitter and the antenna isolating transformer, and another such ammeter 
(switchable between 5A and 500mA FSD) between the isolating transformer and the 
earthy end of the antenna matching network.. The intended impedance at this 
point is 50 ohms.

Hope this helps, John

> On 18 Oct 2015, at 19:28, Chris Wilson <[email protected]> wrote:
> 
> 18 October 2015
> 
> 
> I have a Scopematch box in circuit between LF amplifier and feeder
> co-ax, inside the shack. Does the current waveform simulate the same
> thing as a current meter? Or should a current meter be placed on the
> actual aerial wire itself, high voltages be damned? Thanks.
> 
> 
> 
> -- 
> 
> 
> Best regards,
> Chris                            mailto:[email protected]
> 
> 

[email protected]

Researching history of RABSON, BLACKSHAW, GAUNTLETT, VERLANDER and ROBSONNE






<Prev in Thread] Current Thread [Next in Thread>