SpecLab's digimode terminal will generate audio tones in QRSS directly.
"Just" open the digimode terminal and select a predefined mode, QRSS-3.
Select the output tone frequency.Open the components window and enable
the audio sound output.
You must spend some time to play with SL to find how it works. After
some time it becomes managable ;-)
type the text which you want to TX in the lower text field. Press F2,
F3, F10 to start the transmission.
73, Stefan/DK7FC
Am 12.01.2013 18:15, schrieb Roger Lapthorn:
Thanks for replies so far, but I am still unable to see how to
output a QRSS audio tone e.g. from QRS or Multitone software to an external
audio card like SignaLink USB when using a laptop with only USB
interfaces. It seems quite a simple requirement so am surprised not to
find this supported.
OK I could built an audio derived PTT keyer using the line out, but it
would be so much simpler to use the SignaLink USB interface for all
data modes and, as far as I can see, there is no software to support
this. I am excluding Spectrum Laboratory, which I'm afraid I find very
hard to use and remember how to use!
Help!
73s
Roger G3XBM
|
|
