Graham,
> This all started with WSPR
yes I know... but let me suggest two points
you might consider adopting in future Op versions:
With WSPR v2, there is a "BFO" setting
allowing to configure the RX audio frequency range. The TX frequency
can be edited as well. For example, my LO is fixed on 135.5 kHz, and
the default 1500 Hz centered band would be useless here.
When WSPR has found a signal, it adds the
measured audio frequency to the selected LO, and reports the QRG with 1 Hz
accuracy in each spot.
Best 73,
Markus (DF6NM)
Sent: Saturday, September 08, 2012 10:06 PM
Subject: Re: LF: LF/MF night and weekend
This all started with WSPR , 'we'
had to introduce the the idea of ' Dial set
usb' or half the LF/MF Rx stations
where off frequency , as the mode
expected a normal ssb /tx/rx ..then
came the PIC coders and things soon got out
of hand .as we had work out offsets
. now cw operators
are using 'semi-data' and we start all over again
..
In normal use , Op anti-collision system ( 2.5 Hz
space) places the carrier in the lowest s/n
slot , as determined in the last 2 seconds
before the Tx is keyed , so the frequency
will change from each over ..
We are all appliance operators now .. ,
'Appliance of Science' !
G..
Sent: Saturday, September 08, 2012 8:43 PM
Subject: Re: LF: LF/MF night and weekend
Clemens,
Stefan is actually transmitting on 478.70
kHz...
I would generally prefer exchanging real RF
frequencies rather than a "dial frequency" setting, which I find more
confusing than helpful. It would also be nice if the web reports would mention
the precise receive frequency. After all, we wanna be real radio amateurs and
not black box users (aka appliance operators ;-).
Best 73 and good luck,
Markus (DF6NM)
Sent: Saturday, September 08, 2012 8:12 PM
Subject: Re: LF: LF/MF night and weekend
>I just started my TX in OP4 mode on 477 kHz dial. Will
run in until sunday evening
Stefan,
wouldn't it be better to choose a slightly different qrg to avoid
interfering with the carrier
of the 'RP' NDB beacon (which is BTW masking your signal
here)?
Perhaps 500Hz up or down would be fine.
73
Clemens
DL4RAJ
...
