Hi All
I am running my QRPp MEPT again this
morning all reports welcome. Just a note on receiving the QRSS3. :-
Using Spectran in - Preset QRSS3 - from the
- Mode - menu. With the standard settings and dial on the WSPR dial frequency
502.4KHz my signal will be around 800 on the Spectran Waterfall.
Spectran will run at the same time as WSPR
so those looking for WSPR signals can spot the evil Data and evil non qso
Visual QRSS at the same time.
Frequency 503.22KHz
Modulation QRSS3 FSK, mainly, I do vary
it, maybe some periods of 5/5/5 Morse
Power 500mW at 50 Ohms
Total current consumption 96mA at 12 Volts
Antenna 6m Top Load Vertical
ERP >1mWatt
Eddie
G3ZJO IO92ng
