|
Hi,
Eddie.
Screenshot attached. You are "O" copy here, and I think
the QRB is about 100 km. The antenna here is a
20m "Tee" at 5m, and the RX is a Wandel & Golterman SPM-30 with a 24 Hz
IF bandwidth
By the
way, you are transmitting a hybrid QRSS-DFCW signal, which contains elements of
both modes!
(With
QRSS, one sends dots and dashes on a single frequency, and drop the carrier
between characters, just like regular speed CW. With Double frequency CW, dots
and dashes are equal length, but on mark and space frequencies, and the carrier
drops between letters.)
73,
Dave G3WCB IO91RM nr Windsor, S.E.England
Hi
All
I am running my QRPp
MEPT again this morning all reports welcome. Just a note on receiving the
QRSS3. :-
Using Spectran in -
Preset QRSS3 - from the - Mode - menu. With the standard settings and dial on
the WSPR dial frequency 502.4KHz my signal will be around 800 on the Spectran
Waterfall.
Spectran will run at
the same time as WSPR so those looking for WSPR signals can spot the evil Data
and evil non qso Visual QRSS at the same time.
Frequency
503.22KHz
Modulation QRSS3 FSK,
mainly, I do vary it, maybe some periods of 5/5/5
Morse
Power 500mW at 50
Ohms
Total current
consumption 96mA at 12 Volts
Antenna 6m Top Load
Vertical
ERP >1mWatt
Eddie
G3ZJO IO92ng
No virus found in this incoming message.
Checked
by AVG - www.avg.com
Version: 9.0.730 / Virus Database: 271.1.1/2639 -
Release Date: 01/22/10 19:33:00
|
