Am 08.01.2014 22:44, schrieb Clemens Paul:
Hi Stefan,
I hoped you had forgotten to remind me. :-)
;-) I've learned from YLs that it's never good to promise something
(sometimes they even said i've promised although i didn't! ;-) ). Better
is "most likely" or "if all works well" or so ;-)
Seriously,today I soldered (not smoked) the hopefully last joint
in the interface between the PA and the IC-706.
The PA has been tested successfully on monday evening on a dummy load.
I measured 6,56Np over 1mW which should do for a start.
Wuuw, Np! So P= 1 mW * 2.718 EXP(6.56) = 706 mW ??
Or is that ERP?
But there had to be thrown together a few relays,switches,diodes,LEDs,transisor
etc.
to enable SAFE T/R operation with the 706 together with the PA and with an
extra receiver (no cw filter in the 706).
I also had to measure the TX delay time between PTT (open collector) and RF
output
and so on.
This took more time than estimated (as always).
I will test the interface tomorrow evening and if it works as intended I'm
ready for qso.
Will post here on the list when ready to go.
RR.
73, Stefan
73
Clemens
DL4RAJ
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Stefan Schäfer
Sent: Wednesday, January 08, 2014 9:48 PM
To: [email protected]
Subject: LF: Clemens on MF!!
Hello Clemens,
Now, 2 weeks are gone! Are you QRV? How many QSOs have you
done today?
:-) Sked?
73, Stefan/DK7FC
Am 25.12.2013 12:30, schrieb Clemens Paul:
I promise you to be on air within the next two weeks
(within my vacation) :-))
73
Clemens
DL4RAJ
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of C. Groeger
Sent: Tuesday, December 24, 2013 10:01 PM
To: [email protected]
Subject: RE: LF: RE: SAQ December 24th, 2013 received in
Milano - Italy
Hi Clemens,
What about your mf tx?;-)
I remember you intended to be qrv on xmas:-)
73, df5qg
Christian Groeger
|
