Hi Stefan,
>> I measured 6,56Np over 1mW which should do for a start.
>Wuuw, Np! So P= 1 mW * 2.718 EXP(6.56) = 706 mW ??
Try ln [SQRT (P/0,001W) ] = 6,56Np
Solve for P which is a bit tedious and you end up with
P= e^(2*6,56+ln 0,001)
Or you convert Np directly into dB which is much simpler (1Np = 8,686dB) ...
73
Clemens
DL4RAJ
>-----Original Message-----
>From: [email protected]
>[mailto:[email protected]] On Behalf Of Stefan Schäfer
>Sent: Wednesday, January 08, 2014 11:58 PM
>To: [email protected]
>Subject: Re: LF: RE: Clemens on MF!!
>
>
>Am 08.01.2014 22:44, schrieb Clemens Paul:
>> Hi Stefan,
>>
>> I hoped you had forgotten to remind me. :-)
>>
>;-) I've learned from YLs that it's never good to promise something
>(sometimes they even said i've promised although i didn't! ;-)
>). Better
>is "most likely" or "if all works well" or so ;-)
>> Seriously,today I soldered (not smoked) the hopefully last joint
>> in the interface between the PA and the IC-706.
>> The PA has been tested successfully on monday evening on a
>dummy load.
>> I measured 6,56Np over 1mW which should do for a start.
>>
>Or is that ERP?
>> But there had to be thrown together a few
>relays,switches,diodes,LEDs,transisor etc.
>> to enable SAFE T/R operation with the 706 together with the
>PA and with an
>> extra receiver (no cw filter in the 706).
>> I also had to measure the TX delay time between PTT (open
>collector) and RF output
>> and so on.
>> This took more time than estimated (as always).
>> I will test the interface tomorrow evening and if it works
>as intended I'm ready for qso.
>> Will post here on the list when ready to go.
>>
>RR.
>
>73, Stefan
>
>> 73
>> Clemens
>> DL4RAJ
>>
>>
>>
>>
>>> -----Original Message-----
>>> From: [email protected]
>>> [mailto:[email protected]] On Behalf Of
>Stefan Schäfer
>>> Sent: Wednesday, January 08, 2014 9:48 PM
>>> To: [email protected]
>>> Subject: LF: Clemens on MF!!
>>>
>>> Hello Clemens,
>>>
>>> Now, 2 weeks are gone! Are you QRV? How many QSOs have you
>>> done today?
>>> :-) Sked?
>>>
>>> 73, Stefan/DK7FC
>>>
>>> Am 25.12.2013 12:30, schrieb Clemens Paul:
>>>
>>>> I promise you to be on air within the next two weeks
>>>> (within my vacation) :-))
>>>>
>>>> 73
>>>> Clemens
>>>> DL4RAJ
>>>>
>>>>
>>>>
>>>>> -----Original Message-----
>>>>> From: [email protected]
>>>>> [mailto:[email protected]] On Behalf Of
>C. Groeger
>>>>> Sent: Tuesday, December 24, 2013 10:01 PM
>>>>> To: [email protected]
>>>>> Subject: RE: LF: RE: SAQ December 24th, 2013 received in
>>>>>
>>> Milano - Italy
>>>
>>>>> Hi Clemens,
>>>>> What about your mf tx?;-)
>>>>> I remember you intended to be qrv on xmas:-)
>>>>> 73, df5qg
>>>>>
>>>>> Christian Groeger
>>>>>
>>>>
>>>
>>
>>
>
|
