Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

LF: Re: Re: Re: TX system at DK7FC, schematic

To: <[email protected]>
Subject: LF: Re: Re: Re: TX system at DK7FC, schematic
From: "mal hamilton" <[email protected]>
Date: Sun, 18 Dec 2011 11:10:47 -0000
References: <CAA8k23Rn9WpQM3Ukf=cq5-bLmWy+o4SEsH2abf7cAX=BpLWExQ@mail.gmail.com> <op.v6k16ktpyzqh0k@pc-roelof> <033201ccbcab$5c5fe640$1502a8c0@Clemens04> <op.v6mtuugnyzqh0k@pc-roelof> <000901ccbcc4$42768fe0$c763afa0$@com> <[email protected]> <002c01ccbd6f$572761c0$0401a8c0@xphd97xgq27nyf> <39D91133A64A480596FBAA4395D85812@JimPC>
Reply-to: [email protected]
Sender: [email protected]
Tnx Jim
That explains it, by adjusting the number of secondary turns in series with
the main coill a match can be found.
73 Merry Xmas and HNY.
You have not been active for some time expect you are busy at work holding
the nation  together !!




----- Original Message -----
From: "James Moritz" <[email protected]>
To: <[email protected]>
Sent: Sunday, December 18, 2011 10:58 AM
Subject: LF: Re: Re: TX system at DK7FC, schematic


> Dear Mal, LF Group,
>
> > I can see you resonate your 3mH coild with a motor driven variometer but
> > how
> > do you match this to exactly 50 ohmz for a SWR of 1:1 to the TX
> > I can see your coil and transformer secondary are  in series to earth
but
> > no
> > adjustment for matching.
>
> Essentially the same arrangement is in use here. The transformer ratio is
> adjusted to match the antenna resistance to 50ohms.
>
> A Q of 1000 is typical for a coil of this size wound using Litz wire. You
> might increase that somewhat by optimising length, diameter, winding pitch
> etc. For something big like the Balboa loading coil in Alex's mail, Q can
be
> considerably higher - Watt's "VLF Engineering" has data on this particular
> antenna system - the coil resistance at 25kHz is about 0.06ohms, and the
> reactance 225ohms, making the Q about 3800 - it might be higher at 136k,
> since reactance often increases faster than loss resistance as the
frequency
> goes up. Incidentally, I estimate L of the main loading coil about 1.3mH,
so
> GW0EZY would need the variometer in series as well ;-)
>
> Cheers, Jim Moritz
> 73 de M0BMU
>
>



<Prev in Thread] Current Thread [Next in Thread>