|
Anyone know mods to enable the TX of the IC7000
below 1500 KHz?
Fausto IK4NMF
----- Original Message -----
Sent: Friday, October 29, 2010 8:33
PM
Subject: RE: LF: Re: IC718 problem
Hi
Dave
I have a mk2G and
once you?ve done the diode tx mod it goes to tx mode 0 to 30mhz, however RF
out is minimal much below 250khz, as you get above 400khz it rapidly spools up
to 25w or so max. My 735 is a bit drifty but fine for WSPR, though the
frequency over-reads by about 20hz or so. The 706mk2g is spot on
however. Not sure about the mk2 or the mk1 and what they can
do.
Cheers
Jim
I have an old IC735 which I have modified to give a
good output from the transverter socket down to 136 (I removed a HPF) but the
thing drifts horribly, no good for anything more than QRSS3. A 706 would be
better. Which versions can be made to go into TX below 1.6MHz? I don't think a
MkIIG can but can a MkII?
From: James
Cowburn <[email protected]>
To: [email protected]
Sent: Friday, 29 October, 2010
11:02:12
Subject: RE: LF: Re:
IC718 problem
Dear
All,
Find an old Ic735 or
better still a 706mk2g and open it up. Rx is a bit dull but a datong vlf adaptor will
do the trick too and you have a capable 137/500 transcieve
kit
Jim
G7NKS/GI7NKS
On 27 Oct 2010, at 15:19CEST, L.v.Erck
wrote:
These days I 'm using the good old T-1154 on 502 kHz,
but is drifting down below the 501 kHz (Our limit in the Netherlands
).
Nessun virus nel messaggio in arrivo.
Controllato da AVG -
www.avg.com
Versione: 9.0.864 / Database dei virus: 271.1.1/3224 -
Data di rilascio: 10/28/10 08:34:00
|
