Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

Re: LF: QRV on 503kHz

To: <[email protected]>
Subject: Re: LF: QRV on 503kHz
From: "dl2hre" <[email protected]>
Date: Tue, 29 Jan 2008 22:05:47 -0000
Organization: Arcor Online
References: <001001c86269$202430f0$0d01a8c0@acer5gi5q0ubzj><[email protected]><[email protected]><[email protected]> <[email protected]>
Reply-to: [email protected]
Sender: [email protected]

hello Rick, LF.

just cpy OR7T 549 deep qsb in qso SM6BHZ 579, any time ago cpy on 502KHz GM4SLV 439 also deep qsb.
congrats Rick! i hope for x-band qso next time.

73 Ed DL2HRE JO51TQ
----- Original Message ----- From: "Rik Strobbe" <[email protected]>
To: <[email protected]>
Sent: Tuesday, January 29, 2008 7:09 PM
Subject: Re: LF: QRV on 503kHz


Dear Ha-Jo and all,

I will stick to regular CW as long as the PA heating problem is not solved.
I will try to listen on 3533 but I will have to use the 500kHz antenna.
If I listen on 3533 I will announce it on 503

73, Rik  ON7YD - OR7T


Quoting [email protected]:

dear Rick,

I shall also listen on 503.1 kHz tonight. Crosband qso possible.

73 Ha-Jo, DJ1ZB

"Paul-Henrik" <[email protected]> schrieb:
Any plans for X-band already this evening? Will look for your signals in any
case.

Good luck!

Paul-Henrik / OH1LSQ
Vaasa / KP03SD


Quoting Rik Strobbe <[email protected]>:

> Dear all,
>
> I just finished my 500kHz antenna, 9m high and 26m long T-antenna.
> With a temporary PA (abt 100W) I can get 1.3A into the antenna,
> guestimated ERP is about 0.5 Watt. Enough to put a nice signal on the
> Shetland grabber.
> I will try to be QRV tonight (abt 20-22UTC) on 503,1kHz.
> The setup is very experimental, PA is getting quite hot and TX/RX
> switching is by swapping a cable. So be prepared for some TX-delays
> and short transmissions.
> I will be using my short call: OR7T
>
> 73,
>
> Rik
>
> ON7YD - OR7T
>
> Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
>
>
>











Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm




<Prev in Thread] Current Thread [Next in Thread>