Chris,

Am 04.01.2019 18:45, schrieb Chris Wilson:

Hello  LF'ers,

My newly arrived Ublox 8 and breakout board has landed and I have had
a very quick play with it and the Ublox UCentre software. I have set
Time0 to give say a 1 mHz output in UBX / CFG / TP5 but scoping that
through hole on the breakout board shows no output. I did instruct it
to write to the device, and it sticks. What I am unsure about is where
I should be taking the scope ground to, I used the shell of the USB
connector socket. i am hoping it's not a fake or knackered... It came
from the same place Stefan suggested and is the same model and same
break out board he posted. Any idea if it's me being stupid again, and
I have overlooked the obvious? Thanks.