To: | [email protected], Chris Wilson <[email protected]> |
---|---|
Subject: | Re: LF: FET driver driven direct from a Si5351a questions |
From: | DAVE PICK <[email protected]> |
Date: | Fri, 12 Oct 2018 16:16:18 +0100 (BST) |
Dkim-signature: | v=1; a=rsa-sha256; c=relaxed/simple; d=virginmedia.com; s=meg.feb2017; t=1539357378; bh=Tmypx8bQ9goEBLr6dEV8clg0JaqWRkcMRQOfjOMQ6Kk=; h=Date:From:To:In-Reply-To:References:Subject; b=ZRr02dtsA7hSm48wc0vu4+KOpaVb0c1Aaz5lxJwG0zo21XAZ5gnDN0EHXVUmle3RC JinhGxBwN6qLMmKnp4LkgvmHFbvvmsB7w4XDtm3Bfz8AZ2RBttQDkK2NKS6QYfMT8x 59yE/khyk4fpO1fFCyM59JKeFqq/rlm6E10Edft56TVcYGFIe5aQpHiz/ArWcYRzQ7 bhDwlbvQkN9wo9xub0fVj2wFE7XwWVXT5OAulygAI5JZ41Ci9lrQ3jyVaHAKVprov1 D6Sy41hipmQwwMuxzrvouojABenM5PMUyrX9XD2iMhYAz6LAJ2UKJMmNIcOSdH6YDo W/fq3LcmqJeFQ== |
Importance: | Medium |
In-reply-to: | <[email protected]> |
References: | <[email protected]> <CA+GfORvSpdQUKB_ejMmn4i4UxzN6i8XuvrkZYpNPmyz5Okx2-g@mail.gmail.com> <[email protected]> |
Reply-to: | [email protected] |
Sender: | [email protected] |
Chris The squiggles don't look too bad, are you sure it's not just pick-up on the oscilloscope probe? It makes a big difference where you put the earth clip in a high-current circuit. Dave G3YXM > On 12 October 2018 at 13:42 Chris Wilson <[email protected]> wrote: > > > > > Hello David, > > Thanks for the reply. I will try this I take it you just tie Input A > and Input B together and feed it a x2 signal with X2 tone spacing if > using WSPR? I am pretty sure there's either harmonics or another > frequency riding on CLK1 when in this new Iv mode so I am moving away > from that as you suggest. I now have a refreshed set up whereby I am > able to use the TS-590 for sensible TX operation of JT-9 with either the > Red Pitaya or the 590 as the receiver. So when the LF antenna is > operational at your end I should be able to work you :) > > Thursday, October 11, 2018, 9:36:03 PM, you wrote: > > > Hi Chris. > > Not sure I have a solution for the circuit you have. > > > However, it may be worth not using the 180 degree outputs from the > > Silab oscillator. Have you thought about the advantages of a FET driver > > that has a common input but 2 antiphase outputs ?? > > The TC4428 is an example. They take great care with rise times and > > propagation delays....perhaps the Si device does not give 'perfect' waveforms. > > > > Worth a try ?? > > > > regards > > > > David > > > > > -- > Best regards, > Chris mailto:[email protected] > > |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: LF: FET driver driven direct from a Si5351a questions, Chris Wilson |
---|---|
Next by Date: | Re: LF: FET driver driven direct from a Si5351a questions, David Bowman |
Previous by Thread: | Re: LF: FET driver driven direct from a Si5351a questions, Chris Wilson |
Next by Thread: | Re: LF: FET driver driven direct from a Si5351a questions, David Bowman |
Indexes: | [Date] [Thread] [Top] [All Lists] |