Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

Re: LF: Iron dust toroids and heating/H bridge

To: <[email protected]p.org>
Subject: Re: LF: Iron dust toroids and heating/H bridge
From: "Graham" <[email protected]>
Date: Fri, 26 May 2017 22:21:04 +0100
Importance: Normal
In-reply-to: <[email protected]>
References: <[email protected]> <[email protected]> <[email protected]> <[email protected]>
Reply-to: [email protected]
Sender: [email protected]
Stefan

I now have the  cct's tnx  .

The H bridge seems a interesting design, one point , the amp is on frequency , F in = F out ? in which case , solves the problems linked to data ...
Composite driver  IC's  are available  for  the  H configuration,

Have  you looked at these ? ?,

would seem to simplify construction , to a single out put transformer , whilst producing less harmonic power ... ?
Tnx -G,
G0NBD

--------------------------------------------------
From: "DK7FC" <[email protected]>
Sent: Thursday, May 25, 2017 1:09 PM
To: <[email protected]>
Subject: Re: LF: Iron dust toroids and heating

Hi Chris,

Am 25.05.2017 12:40, schrieb Chris Wilson:
I was wondering if the #3 material which is rated for use from 0.05 to
0.5 MHz, and has several times the permeability would be a better
choice for more power through it? It probably gives a higher Q with
fewer turns, allowing the use of larger wire without having
overlapping layers in the winding?

Yes that sounds like a good concept.

It is interesting to follow your plans. Actuelly i would like to try to build a 2.5 kW or larger PA as well, just for interest of course. I would of course use it together with a dummy load only, because you must not radiate more than 1 W here in DL, and i am a conformist and under the spell of authorities (german: autoritätshörig) :-) It would be interesting to deal with the problems that would appear with such PAs. For say 3 kW and the comfortable situation to have a suitable 60 V power supply, i would simply build a current mode class D PA, hard keyed with an IXDD614CI and 2x 4x IRFP260N FETs. For the LPF i would use the T225A-2 together with RF litz wire, maybe 250x0.1mm, available at https://www.spulen.com/hf-litze-250-x-0-1-mm-100-g-spule.html and WIMA-FKP-1 capacitors, the 2 kV version...
Good luck and fun with your projects.

73, Stefan

---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus


<Prev in Thread] Current Thread [Next in Thread>