Same message, updated subject.
Am 17.02.2013 23:39, schrieb Stefan Schäfer:
Hi Dimitris,
Thanks for the informations.
Well, if 475.7 kHz is not a good choice due to QRM in VK, then "we"
should discuss where to go.
"We", that must be explained. I think that "we" are those active
stations who either want to try to receive a station from VK or want to
try to get a decode in VK.
Of course i would like to join those active TX stations on MF and i
like to try if i can leave a trace or decode, not only in the sand :-)
I thought about running QRSS-10 near 476.170 kHz, as done in the last
months. This would allow me to run the TX during the complete possible
time, arround 15:30...18:00. Or, alternatively, i would like to run
WSPR-2 in 100% TX mode. That would at least require splitted RX and
TX bands on both sides, otherwise there will be complaints. There
will be complaints anyway, im afraid...
So maybe it would be an idea to define a special slot just for this
path and time and active (RX and TX) stations so they can all run
WSPR-2 in 100% mode. Of course there must be stations who are RXing
exclusively but there are only a few who will TX anyway.
Any recommendations / ideas? Should we discuss in direct emails
including all those from VK who are not member of this group?
I would start the MF experiment tomorrow.
73, Stefan/DK7FC
|
|
