Ok John..
That set up may be a problem for dual watch with only 1 rx
If you set the TX to 500K usb and the MFSK4 to say 2KHz , that
will fit inside the USB filter
and allow monitoring / tx either mode .. also allows tx of MFSK &
ROS via the same Tx ?
G.
--------------------------------------------------
From: "John GM4SLV" <[email protected]>
Sent: Saturday, September 03, 2011 4:16 PM
To: <[email protected]>
Subject: LF: Dual mode test MFSK/ROS
Graham, Gary, LF
I've had MFSK4 running (with a few interruptions) for a few hours now,
and no sign of reports from stations to the south!
I've just hooked up a second RX on 500.000kHz dial feeding audio to the
netbook running ROS - in RX only mode.
I'll continue to send MFSK4 beacon - now with a 3 minute gap between
each transmission - on dial 502.4 / AF 1kHz (the antenna is tuned at
the top end of the band at present)
Fldigi is set to report via PSKReporter - so any MFSK4 spots I get
should become visible via the web.
In parallel I'll listen (and report via ROS/PsKreporter) for ROS
MF2/MF7 on the standard 500 dial QRG.
Interested to see if I can receive signals from either/both modes over
the oncoming transition to darkness.
Regards,
John
GM4SLV
|
