Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

LF: Re: Soldering enamelled copper wire

To: <[email protected]>
Subject: LF: Re: Soldering enamelled copper wire
From: "mal hamilton" <[email protected]>
Date: Wed, 23 Feb 2011 11:57:31 -0000
References: <[email protected]>
Reply-to: [email protected]
Sender: [email protected]
Yes
You scrape the enamel from the area to be soldered to reveal the bare copper
wire then solder in the normal way.
G3KEV

----- Original Message -----
From: "John Rabson" <[email protected]>
To: <[email protected]>
Sent: Wednesday, February 23, 2011 10:23 AM
Subject: LF: Soldering enamelled copper wire


LF,

I have a reel of such wire labelled as follows:

"Wire copper enamelled
Part 1230983 0.71 mm 1/2 kg
Solder only in well ventilated area. Fumes are toxic"

The manufacturer is stated to be Rowan Cable Products Ltd.  I found their
website but don't seem able to get into it to find out whether the covering
of the wire is solderable and (if so)  whether any special techniques are
required.

Can anyone advise, please?

73
John F5VLF



<Prev in Thread] Current Thread [Next in Thread>