Re: LF: Re: 500 kHz BPSK08

[Gary - G4WGT <g4wgt@tiscali.co.uk>]

Hello Markus,

Thank you for your decode via the Twente Web SDR. It is almost 100% with just the word transmission with an incorrect letter. Not sure were the {10} comes from at the start, just another small error.

I am monitoring 503.400 to 504.000 kHz but not seen the PSK31 signal.

Thanks for looking.

73, Gary - G4WGT.

On 31 January 2010 20:05, Markus Vester <markusvester@aol.com> wrote:

Dear Gary,

 

decoded from the Twente Web-SDR audiostream a few minutes before 20 UT:

 

{10}Test transpission from G4WGT

Locator IO83qo

Tx RF 5Ø watts

ERP 2ØØ mW

Mode and station control by SpecLab

Test de G4WGT

 

There was also a weaker PSK31 signal a few Hz up for a short while.

 

Best 73,

Markus, DF6NM

 

----- Original Message -----

From: Gary - G4WGT

To: LF Group (RSGB)

Sent: Sunday, January 31, 2010 6:01 PM

Subject: LF: 500 kHz BPSK08

LF,

I will be operating a beacon this evening using BPSK08 mode.

The frequency will be 503.600 kHz dial set at 502.600 kHz USB.

I will be using SpecLab Digital Terminal, the Tx & Rx offset will be 1000 Hz.

Tx RF output 50 watts & ERP about 200mW.

I will look forward to & welcome any reports & (dare I say it) any replies/calls in that mode.

The beacon will be operated in manually so times between Tx will vary.

73, Gary - G4WGT.