|
Dear Gary, Jim,
well essentially I did the same thing that Jim
did. The audio frequency was not known beforehand as there is a bit of
rounding in the SDR tuning (in this case 503.308 instead of 503.300
kHz). Then I used manual fine tuning in +-0.1 Hz steps. The extra {10} may be just SpecLab's way of displaying a
linefeed.
73, Markus
----- Original Message -----
Sent: Sunday, January 31, 2010 10:47
PM
Subject: Re: LF: Re: 500 kHz BPSK08
Hello Jim,
Well not 100% but it looks like you did a bit of juggling. Marcus had
great success using the Twente Web SDR but didn't say if he had to jiggle
things first. I would have thought you would easily get 100% but not so.
Thank you for your report & comments.
I will be closing down about 2200utc.
Cheers, Gary - G4WGT.
On 31 January 2010 20:48, James Moritz <[email protected]>
wrote:
Dear
Gary, LF Group,
This is what I see at M0BMU at
2042utc:
{10}Test transmission from G4WGT
Locator
IO83qo
Tx RF 5Ř watts
ERP 2ŘŘ mW
Mode and station control by SpecLab
Test de
G4WGT
To get successful decoding, I had to set the AFC
to off, measure the center frequency of the signal from the waterfall and
set this manually as the RX frequency.
Cheers, Jim
Moritz
73 de M0BMU
----- Original Message -----From: "Gary -
G4WGT" <[email protected]>
To: "LF Group (RSGB)" <[email protected]>
Sent: Sunday, January 31, 2010 5:01 PM Subject: LF: 500
kHz BPSK08
LF,
I
will be operating a beacon this evening using BPSK08 mode.
The
frequency will be 503.600 kHz dial set at 502.600 kHz
USB.
|
