Just realised.  The WSPR Software won't accept any-old value typed
into the Tx power box.  It has to be one from a pull down menu.
Nearest options are 23 or 27dBm.

Andy  G4JNT
www.g4jnt.com



2009/1/25 Andy Talbot <[email protected]>:
> I thought I'd set an ERP of 25dBm in the setup, will have to check...
>  My ERP is around that figure when hitting antenna with 80 Watts.
>
> Not too happy with the WSPR windoze software.  The COM port operation
> of Tx doesn't, properly.   On going from Tx to Rx it blips the RTS/DTR
> lines but then stays with them active.  So the right port is selected
> (COM1 ), but they are not toggling properly, just a quick blip.
> Other software handles the DTR / RTS control properly.
>
> Audio VOX required, methinks.
>
>
> Andy  G4JNT
> www.g4jnt.com
>
>
>
> 2009/1/25 John P-G <[email protected]>:
>> Hello Andy & LF,
>>
>> I've just started receiving WSPR transmission from Andy G4JNT, first
>> decode seems to have been 0902 UTC
>>
>> All spots are being uploaded to WSPRnet
>>
>> Nice work, for daytime, almost 1100km, well done.
>>
>> Your WSPR signal impliesTX power of 0dBm - it that estimated ERP, or a
>> configuration error?
>>
>> Cheers,
>>
>> John
>>
>>
>