I thought I'd set an ERP of 25dBm in the setup, will have to check...
 My ERP is around that figure when hitting antenna with 80 Watts.

Not too happy with the WSPR windoze software.  The COM port operation
of Tx doesn't, properly.   On going from Tx to Rx it blips the RTS/DTR
lines but then stays with them active.  So the right port is selected
(COM1 ), but they are not toggling properly, just a quick blip.
Other software handles the DTR / RTS control properly.

Audio VOX required, methinks.


Andy  G4JNT
www.g4jnt.com



2009/1/25 John P-G <[email protected]>:
> Hello Andy & LF,
>
> I've just started receiving WSPR transmission from Andy G4JNT, first
> decode seems to have been 0902 UTC
>
> All spots are being uploaded to WSPRnet
>
> Nice work, for daytime, almost 1100km, well done.
>
> Your WSPR signal impliesTX power of 0dBm - it that estimated ERP, or a
> configuration error?
>
> Cheers,
>
> John
>
>