Hi Graham,
right now your signal coming up, weak but audible with CW filter.
As I just downloaded & installed WSRP I followed the instructions that
say receiver in USB at -1500Hz of the desired RX frequency. That
worked well with the SSB filter (despite the awfull noise at 2700Hz
bandwidth).
But the instructions are "basic" as is the help function.
If it would be possibe to decode at 800Hz audio I could use the CW
filter and win a lot of dB's.
As I understand WSPR seems a "monitor mode", any option to make a QSO
(ie. exchange reports)?
73, Rik ON7YD -OR7T
Quoting Graham <[email protected]>:
Ok Rick
Thanks for report .. also your test or7t last night 5/5/9
Tnx- G ..
--------------------------------------------------
From: "Rik Strobbe" <[email protected]>
Sent: Saturday, November 29, 2008 10:10 PM
To: <[email protected]>
Subject: Re: LF: RE: K1JT WSPR BEACON 503 KHZ - NOW TILL LATER !
Graham,
here (jo20IX) good copy at -25dB
73, Rik ON7YD / OR7T
Quoting Gary - G4WGT <[email protected]>:
Hi Graham, LF,
No problem here.
081129 2012 36 3 1.3 0.502999 G0NBD IO83 27 0 1 0
081129 2016 36 4 1.2 0.502999 G0NBD IO83 27 0 1 0
081129 2022 36 4 1.3 0.502999 G0NBD IO83 27 0 1 0
081129 2030 37 4 1.1 0.502999 G0NBD IO83 27 0 1 0
73
Gary - G4WGT.
_____
From: [email protected]
[mailto:[email protected]] On Behalf Of Graham
Sent: 29 November 2008 17:34
To: [email protected]
Subject: LF: K1JT WSPR BEACON 503 KHZ - NOW TILL LATER !
Hi Lf ..
Running K1JT WSPR beacon 20 % tx
Carrier frequency 503 KHz
Dial set 501.5 Khz usb , audio tone 1500 Hz
Running approx 75 watts to 35 ft top loaded vertical ,
(If the pa trips beacon will continue at -14 db level)
Reports welcome
Tnx - Graham
G0NBD / IO83LK
Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.176 / Virus Database: 270.9.11/1819 - Release Date:
11/29/2008 10:37
Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
|
