Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

Re: LF: Datong

To: [email protected]
Subject: Re: LF: Datong
From: "hamilton mal" <[email protected]>
Date: Sun, 12 Oct 2003 17:37:19 +0100
References: <[email protected]>
Reply-to: [email protected]
Sender: <[email protected]>
----- Original Message -----
From: "Dave Sergeant" <[email protected]>
To: <[email protected]>
Sent: Sunday, October 12, 2003 4:13 PM
Subject: Re: LF: Datong


On 12 Oct 2003 at 12:11, hamilton mal wrote:

> Many thanks for the info. I got it from your website above. Have it
> printed out and can now adjust the xtal to get the freq spot on. The
> cal was a bit out.

Pleased to be of assistance Mal. I forgot to mention that I also have
the full paper manual on the UC1 with setting up instructions, but
not currently in electronic form. Let me know if you need anything
else.

I have used the UC1 as part of my (little used) 5MHz station. The
biggest problem with the 28MHz output is that a 116MHz conversion
crystal is used and it is next to impossible to adjust this spot on
frequency and expect it to stay there. The 144MHz output is OK in
this respect as the 28MHz output is derived from it with that
crystal.

PS Apologies for the much delayed email on spam - as Alan probably
knows, the BTinternet email system has been playing up over the past
few days - it was posted on Wednesday honestly..

73 Dave G3YMC
Hello again Dave
The h/book would be useful if you could convert it electronically and send
it or put it on your webpage.
I have two of these machines one old one and a newer version. They both seem
to perform about the same probably the older one has the 1 mhz xtal and the
newer one the 5 mhz xtal.
Any expense involved let me know.
73 and tnx agn
de Mal/G3KEV

[email protected]
http://www.btinternet.com/~dsergeant






<Prev in Thread] Current Thread [Next in Thread>