Rik, LF, I failed to mention Dave's grabber is OK with me at :- http://www.wireless.org.uk/grab/ Gary - G4WGT. Dear all, for various reasons (busy, antenna down due to construction) I haven't been ac
Since it's possible to run WSPR and Spec Lab concurrently I'm running a grabber on 500kHz too Spectrum range shown will be 503 - 505.300 (to include the various beacons) upload at 5 minute intervals
Hi Rik, LF, I did make some changes a while ago, the 500KHz grabbers are operating at :- http://myweb.tiscali.co.uk/wgtaylor/grabber1.html and http://myweb.tiscali.co.uk/wgtaylor/grabber2.html When i
Hello Graham, LF, Yes - I don't think I missed any periods, except of course when listening elsewhere - hi! - so the new soundcard seems to have cured the problem. None at the moment. The original cl
Looking good at the moment John, Last decode at +8 ! frequency should be 950 , but i notice the 504 signal is showing 1 Hz low on the wspr display ... not much I can do about that the rx tunes in 10
Hello Rik, Gary et al, My 500kHz grabber is, in general, offline at the moment. Occasionally I run a temporary setup, as when Paul-Henrik was testing on 136 recently, using my IC-R75 - which is my ma
Yes. I think it might do, we should try one night. Don't believe my freq calibration - the R75 doesn't have the high stab osc, and its internal master osc hasn't been tweaked - although it seems pret
Thanks John, looks like that signal would print rtty ! wspr looks to be ok at the moment .. only +1 hz soundcard sample was rate slightly out .. pity wspr doesn't have a cal facility ?? G .. -- From: