Hi LF Last night the LF coils were connected and started to transmit Op32 with just the 100mW from U3 https://dl.dropboxusercontent.com/u/7162072/fotos%20varias/MF/MF%20and%20LF%20coils.jpg So far, a
Hi Luis, Great! And very nice pictures again. I've been on air on MF last night so there must have been a signal reduction on LF here. Oh, another reason for a LF RX stn on the tree!! ;-) Keep the pa
Am 01.09.2016 12:20, schrieb DK7FC: Keep the parallel C (metallic element) as small as possible and better add a few more turns on the coil, so the tuning range is 135...150 kHz instead of 123...138
Thanks a lot for the transmission, and the report on the report ;-) Nice setup indeed on top of your roof! I believe that the U3 by default does not preserve phase between dashes (possibly depending
Thank you for the phase info Markus Can recall that the first tests last spring with same power and U3 were phase coherent But my U3 suffered a hard reset and turned back to factory default parameter
Hi Luis, All right. I will add a bit more power too :-) The often notice that the signal becomes stronger when rising the power level. I found there is a clear dependency, and BTW it corellates with
Olá Luis, one more detection yesterday and three this morning - we seem to have a private LF duct between us ;-) 73, Markus (DF6NM) --Ursprüngliche Mitteilung-- Von: VIGILANT Luis Fernández <luis@vig
Hi LF Yes Markus. Signal must be following some Ryanair path bouncing from plane to plane :-) Since last night U3 transmits continously frame after frame. No stop to GPS calibration So may be the inc
Hush Luis ! or O'Leary will be wanting to charge us for using his planes as reflectors :-)) Alan G3NYK -- Original Message -- From: [email protected] VIGILANT Luis Fernández To: rsgb_lf_group@blackshe
100 mW to Ae ? to too much power , still 3 db left ! 73-G, ) 23:39 136 EA5DOM de G3XDV Op32 Deep Search 915 mi -42 dB in Welwyn 1520.0 Hz with 0.1w + MiniWhip 23:35 136 EA5DOM de EA5DOM Op32 0 mi -1
Hi LF Last night was 5w !!! :-0 Testing an audio amplifier with dissapointing performances Very interesting spots :-) 73 de Luis EA5DOM El 7 sept. 2016 2:18 a. m., Graham <[email protected]> es
Hi Luis, Oh yes, very nice! DK7FC JN49IK Opera-32 correlation http://df6nm.bplaced.net/opera/opds.zip date time call distance frequency bandwidth snr correlation 2016-09-07 04:35:08 EA5DOM 1398km 137
Hi LF Thank you Stefan. Finally could see a trace in your grabber ! :-) There were also five Opera-32 correlation decodes at Markus grabber 2016-09-07 04:35:09 EA5DOM 1500km 137519.916Hz 141mHz -30.9
Am 07.09.2016 12:16, schrieb VIGILANT Luis Fernández: Time for a D class PA ;-) Output filter and transformer core is already here, so should be easy to get some 50w or more (10dB) That sounds
Ideas wellcome ! :-) I like the W1YD design http://www.w1vd.com/137-500-500WTX.pdf Don't need the keyer and would use an ICL7667 as dual mosfet driver For the mosfets what I have here is a couple of
Ideas wellcome ! :-) I like the W1YD design http://www.w1vd.com/137-500-500WTX.pdf Don't need the keyer and would use an ICL7667 as dual mosfet driver For the mosfets what I have here is a coupl
Hi Luis, Am 07.09.2016 13:33, schrieb VIGILANT Luis Fernández: Ideas wellcome ! :-) I like the W1YD design http://www.w1vd.com/137-500-500WTX.pdf Yes, a very typical design. I would use a diff
Hi Luis, Am 07.09.2016 13:33, schrieb VIGILANT Luis Fernández: Ideas wellcome ! :-) I like the W1YD design http://www.w1vd.com/137-500-500WTX.pdf Yes, a very typical design. I would use a differen
Nice going Luis ! G3XDV and Ik0VVE , similar distance at -32 DB , levels u expect on 477 ! 73-G, op32 decodes ! 2016-09-07 04:35:08 EA5DOM IM98XN G3XDV IO91VT 1.473 136 -32 Op32_||||||||||||_~32dB 20
Hi LF Thank you all for the reports But the audio PA is a hell. The good point is that looking at the results with this I can expect a very decent signal when using 50w and a clear output sinewave (c