Dear Mal, LF Group, At 12:47 11/06/2002 +0100, you wrote: Mine runs ICE COLD. Surprised you have not tried this approach Jim instead of using those big coils!!!!! and all that resistance !!! Really M
Dear Andy, LF Group, At 14:04 11/06/2002 +0100, you wrote: ...Anyway, isn't 2 mix - the red coloured one - the wrong material for this frequency ? I thought that was meant for the 2 - 20 MHz region.
Dear Mal, LF Group, Something is wrong if you need to adjust the tuning within this range - the output should be flat within a fraction of a dB over the whole band without re-tuning. Nothing wrong,
Thought it felt a bit dubious, but I hadn't got the core loss information available so couldn't justify the feeling. Anyway, isn't 2 mix - the red coloured one - the wrong material for this frequency
Dear Andy, Mal, LF Group, Well, up to the point that it won't saturate - but that is just the first hurdle. I was slightly amazed to find the micrometals catalogue at work in my filing cabinet, conta
For info/Decca coil mods. 54 uH coil using powdered iron core (T200 - TYPE) resistance 0.4 ohms using 18 mm enamelled copper wire, single layer. 54 uH coil using original decca paxolin former and ori
Re Tank coil components in LF Transmitters: Use the equation V = 4.44 . F.N.A.B to determine the number of turns needed on a ferrite or iron dust core. The T200 core Mal mentioned, if it is the norma
Dear Mal, LF Group, Something is wrong if you need to adjust the tuning within this range - the output should be flat within a fraction of a dB over the whole band without re-tuning. Incidentally, an
Due to email received, mostly private about the DJ coil mods especially the ferrite approach, the required information follows. Models using the BCB capacitor board, total series capacitance 24nf nee
Dear Mal, LF Group, At 18:58 09/06/2002 +0100, you wrote: Has any Decca Jeep owner considered using ferrite cores for PA coils instead of altering the existing poor quality paxolin air wound devices.
In a message dated 6/9/02 7:02:29 PM GMT Daylight Time, [email protected] writes: Re: Decca Using the original coils the inductance when measured in the case and out of the case varies by several
Has any Decca Jeep owner considered using ferrite cores for PA coils instead of altering the existing poor quality paxolin air wound devices. The originals in spite of being wound with litz wire are