Looks like conditions very poor now so I will not be testing tonight. Get some sleep Hi. I will advise when I start again. Thanks for listening. 73s Laurie.
Many thanks Dex. for listening. Can you confirn that my freq. 72.402kHz is satisfactory ? Conditions have been good so I will continue with the tests. I will however go to 120sec dots for a bit more
After some tests I have decided to change to 90sec dots,this will give a few more db S/N and looks better on 60sec ARGO with the 0.1hZ shift.I will transmit tonight on 72.402 from 23:00utc. All repor
Hi Bob and team, There is a strong carrier/spectral line here on the south coast on 137.46kHz which de-sensitises my reciever. Its possible that others will have the same problem. So I personally wou
I must appologise to all for the trouble and confusion that my mail initiated.The information came to me from a source that I would trust and I passed it on in good faith. (also there was no warning
Many thanks for the report Dex, I actually only transmitted one sequence of AQC since the band was so crowded and I didnt want to add to the confusion,although I was on the freq.that I have used for
Dave and Walter have commented on the crowding around 136.922. We did have an agreed plan which avoided Loran lines and separated stations. It listed frequencies from 135.7080 to 135.7589. 136.9220 k
-Subject: Fw: Virus Alert! - I have received an email saying that I might have a virus that is spread from address book to address book. It is apparently undetectable by Norton and McAfee. It remains
When I came into the shack this morning it was snowing ! rather wet snow,and the ant. wires were about half inch diameter ! I turned on the Decca to check, and NIL no ant. current. Checked the variom
From 1530 today I will beacon specifically for ZL. Will run for about 2 Hours. I will use 135,721.5Hz so as to be clear of other band users. Mode DFCW 120sec dots 0.1Hz shift All reports welcome. 73s
From about 1530utc this afternoon I will transmit 120sec QRS on 135,921.5Hz. +/- 0.2Hz. I will transmit from just before our UK sunset until well after sunrise in ZL and E. Australia.. I know that th
Hi Dex, Thanks for the unexpected report, I was setting up my DFCW generator as close as possible to my old T/A frequency and went on air for a few minutes to check that the signal was clear of the o
Very nice signals here tonight from DF6NM using DFCW on 135,922.4/5Hz, 30db over noise, and OM2TW QRSS on 135.922.(sending TW only) 25db over noise. Best of luck. 73s Laurie.
Thanks for the many reports including the "ART" from Uwe. I fully agree with John re mixed mode/dot rates. I think I have proved the point that 10sec dot DFCW will work on 136 even though cdx. may no
I saw Andys signals last night and decoded them successfully once I had realised that the best way to do it, is as the dots emerge from the right hand side of the screen. Trying to decode a screen fu
Hi All, I am proposing to transmit on 136 tonight. I will be using 10sec. DFCW just below my old T/A frequency. 135.921 dashes and 135.920.25 dots. This should leave plenty of room for Rich OM2TW who
