LF It was mid December 2012 when I threw out JT9-2 as a pigs ear which would not decode more that 5 consecutive transmissions from my Kenwood TS870 due I thought to slight frequency drift. Relevant f
To confirm my signal is on 476100KHz. WSJT dial needs to be 1270Hz below. I am running JT4A on 476.100KHz tonight. Reports welcome QSO's possible mail to blacksheep if I don't respond please. First r
It would be a real miracle Minto:-) Eddie -- Ceterum censeo Carthaginem delendam esse --Original Message-- From: g3zjo Sent: Wednesday, March 06, 2013 15:44 To: [email protected] Subject:
Ok Steinar I will watch blacksheep for when you are active please your tests. I am going to run a test with the new version now. 15.00 UTC Eddie LA5VNA Steinar loc:JO59jq Den 07.03.2013 15:07, skrev
Yes not a lot of hope of much getting through that mess. I do see my WSPR on your Grabber and you were reporting -9dB yesterday. Same QRP here as on WSPR, 10W of RF 5mW ERP from my small Marconi. Edd
Thanks Vern On 11/03/2013 11:26, Vernon Matheson wrote: Hi Eddie....its been a while. Yes, and I don't expect you to see my QRP on 630m. :-) Last night I was using the R75 with just the ssb filter...
HI Henrique I assume we have something to do with:- " Reporting to WSPRnet now includes information about your station being active on a band, and your Tx status, even when no spots have been uploade
On 02/03/2013 15:48, Graham wrote: That would make the nose b/w zero , bit of a 'gray' area that : ) write the spec. this is the spectrum of the 200Hz B/W version http://www.qsl.net/zl1bpu/CMSK/ITU12
Hi G Decided I would go measure the ant, rather than quote what it was going to be. (Would I lie to you baby). 10W RF Ant. Marconi inv. L. Vertical section 3.5m - Top section single wire 7m long. Abs
Thanks Colin That is pretty good over the distance involved.There must be many more stations in ear shot too. Without documentation from JE3HHT we can't be sure of his implementation of GMSK but I th
On 06/03/2013 13:14, Minto Witteveen wrote: That settles it. The info I got (from an untrusworthy source it seems) told me mark is 2125 and space is 2295. See my original message below. But it is the
Installed WSPR-X v0.8 this afternoon. I am sure someone said they had no decodes with it, then said OK now. I have no decodes, does anyone else get Back Door Virus Warnings too? See Att. Eddie G3ZJO
Henrique / LF Looking at the Avast Forum last night, they said they were continually working on false positives for win32evo-gen-susp-virus. This morning after Avast updated its definitions I deleted
OK Gary I will see if the antenna needs retuning for that end of the band later. It's nice here for the garden too. Another world, the other day I was trying to dry out my saturated fire wood which g
Hi Minto I have just on comment below. On 06/03/2013 12:53, Minto Witteveen wrote: Hi Eddie, Yes, after I sent the message I (re)checked and found that I switched mark and space frequencies (due to
Graham Just confirmed by test, MMTTY is backwards compared to all other Software. Others idle on the high tone MMTTY idles on the low, unless the REV is pressed. From Wiki the upper tone used for idl
Hi Roger Thanks for that, always worth a try but you do have trouble with me running1000 times more power. :-) I am hoping G4KPX comes back up, I see G0VQH is RX'ing, good chance of a Spot there. I w
