Hello Stefan,
No, not yet, I need to finalise the positions for the ground rods. Can
I initially lay insulated stranded but each single core UK 15 Amp
mains wires on the ground's surface to the rods? Is 50 yards earth rod
spacing adequate and should I try to get them in a ditch that's
usually constantly wet? I picked up my amp a few weeks back, it looks
quite a beast! Thanks Paul Nicholson :) Toroids should land this week.
Saturday, May 11, 2019, 7:29:56 PM, you wrote:
> Hi Chris,
> Did you already lay out wires? And did you already get the amplifier?
> 73, Stefan
> Am 09.05.2019 16:47, schrieb Chris Wilson:
>>
>> Hello Stefan,
>>
>> Thanks, ordered 3, so get free shipping, it was cheaper than ordering
>> 2 and paying shipping :)
>>
>> Thursday, May 9, 2019, 2:34:58 PM, you wrote:
>>
>>
>>> Hi Chris,
>>>
>>
>>> I would not recommend the one you selected because it has an unnecessary
>>> large inner diameter and a lower height, thus a lower AL value.
>>>
>>
>>> I think this is the same one that i recommended from Bürklin:
>>> https://www.mouser.co.uk/ProductDetail/EPCOS-TDK/B64290A0699X830?qs=sGAEpiMZZMs2JV%252BnT%2FvX8Df1W1GtRs010YpcsJh6dvk%3D
>>> It is also cheaper.
>>> There are other materials available, such as T65, T38, T37, offering a
>>> higher AL value. Maybe these are even more suitable at that sort of
>>> frequency but i didn't spend too much time to select the best core for
>>> each frequency. I use the N30 material from 1 kHz to MF at high power (
>>>
>> >> 1 kW for one core) without problems. So this is what i recommend. It
>>
>>> will work.
>>>
>>
>>> 73, Stefan
>>>
>>
>>> PS: If you want to bridge one of Paul's 2x 7.2 kW amps, you may need two
>>> of them ;-)
>>> PPS: You may want to build two orthogonal ground loops then, one per
>>> channel. With SpecLab you can then drive each channel separately and so
>>> you can build a software rotatable loop by aligning the phase between
>>> the channels, while staying into the shack when its cold and/or rainy :-)
>>>
>>
>>
>>
>>> Am 09.05.2019 14:42, schrieb Chris Wilson:
>>>
>>>> Hello Stefan,
>>>>
>>>> I am now on to building a matching transformer but it seems Buerklin
>>>> have a minimum order of 60 units! I have found this bigger core at
>>>> Mouser, could I use that instead please?
>>>>
>>>> https://www.mouser.co.uk/ProductDetail/EPCOS-TDK/B64290L0730X830?qs=4l9S5vBWkUJtsO6ZFRCS4g%3D%3D
>>>>
>>>>
>>
>>
>>
>>
--
Best regards,
Chris mailto:[email protected]
|
