LF: WSPR-15

[Markus Vester <markusvester@aol.com>]

Hi Chris,

for WSPR-15, I've been using WSPR-X v0.8 r3058 - maybe not the latest and greatest but does the job well under Win-XP. I've just gone and installed on a Win-10 (Home 64 bit) machine, and bingo it ran straight away and seems quite happy - see attached result. It is convenient that the BFO frequency can be changed to accomodate unusual RX or TX frequencies (albeit I vaguely recall that entering other than 1500 Hz somehow prevented uploads to WSPRnet).

Best 73,
Markus

-----Ursprüngliche Mitteilung-----
Von: Chris Wilson <dead.fets@gmail.com>
An: DK7FC <rsgb_lf_group@blacksheep.org>
Verschickt: Do, 6. Sept 2018 20:44
Betreff: Re: LF: Slow JT9 modes...

Hello DK7FC,

First TX at 18:45 my time.

Thursday, September 6, 2018, 7:09:37 PM, you wrote:

> Hi Chris,

> Yes, that should work too. Or, can you reduce the power by 6 dB and then
> work into the WSPR-15 range? If your PA permits.
> You need that auto-variometer :-)

> I'm ready. Tell me when the first transmission is running.

> 73, Stefan

> Am 06.09.2018 20:02, schrieb Chris Wilson:
>>
>> Hello Stefan, it will have to be on my normal 137.550 as I do not have
>> time tonight to re-tune the coil. I need to take the dogs out then I'll
>> swap the antenna over and give it a go. Let me know if 137.550 is
>> acceptable. Thanks.
>>
>> Thursday, September 6, 2018, 6:34:03 PM, you wrote:
>>
>>
>>> Hello Chris,
>>>
>>
>>> I've sorted out some bugs in the configuration, now i should be ready to
>>> receive.
>>> Can you give me a feedback, are you on air? Which TX frequency?
>>>
>>
>>> 73, Stefan
>>>
>>
>>> Am 06.09.2018 15:07, schrieb Chris Wilson:
>>>
>>>> Hello Stefan,
>>>>
>>>> Yes, I can run WSPR-15 OK and have done many times. I drop the voltage
>>>> to the PA in deference to heat production but it works fine if anyone
>>>> is listening :)
>>>>
>>
>>
>>
>>




--
Best regards,
Chris mailto:dead.fets@gmail.com

2e0ily_wspr15_180906.png
Description: PNG image