Always good to hear about these adventures. 20 nS jitter is amazing.
Meanwhile on this side of the pond, the aerial is iced and the current is
quite low since last night but the transmissions on 8.2700075 kHz
continue.
73
Joe VO1NA
On Sat, 17 Feb 2018, DK7FC wrote:
...so it could be an EMC issue. One of the first things i've done is removing
the ribbon cable and the audio jacks and use RG174 instead.
To prevent a galvanic ground loop maybe it is worth to try to use a few turns
RG174 through a ferrite core? It is quickly done...
73, Stefan
Am 17.02.2018 12:31, schrieb Paul Nicholson:
I had a bit of time to play again with the Octo, to investigate
where the excess timing jitter comes from.
The stereo audio injector is giving around 20nS jitter on the
PPS from the neo-m8t.
With the stereo card replaced by the Octo, all else the same,
the jitter varies between 300nS and over 1uS.
A close look at the shaped PPS seen through the Octo shows some
distortion or interference
http://abelian.org/vlf/tmp/180217a.gif
Not sure if these are additive or little step changes in gain.
Here's worse example
http://abelian.org/vlf/tmp/180217b.gif
Always the interference is on the rising and/or falling slopes
about half way.
Not present on the PPS when viewed on a scope at the Octo inputs.
Similar artifacts are visible on a plain old sine wave fed into
an Octo input.
http://abelian.org/vlf/tmp/180217c.gif
For some reason on the sine wave the artifacts are always near
the turning points.
Meanwhile I monitored the 49.152 MHz master oscillator on a
SSB receiver and it was giving a nice pure note with no obvious
frequency or phase jitter.
So it looks like the timing jitter on the Octo is due to its
analog inputs, not the A/D conversion timing.
Strangely though, there's no sign of these artifacts when there's
no input to the channel. It isn't just background interference.
I think the next step might be to bypass the Octo's input board
and take the PPS straight to the pins of the ribbon connector.
Wondering if anyone else sees this behaviour on a PPS or sine wave.
--
Paul Nicholson
--
|
