Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

Re: LF: Si5351A syntehsiser able to fire a FET driver chip directly??

To: [email protected]
Subject: Re: LF: Si5351A syntehsiser able to fire a FET driver chip directly??
From: Chris Wilson <[email protected]>
Date: Tue, 2 Jan 2018 12:21:03 +0000
Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=gmail.com; s=20161025; h=date:from:message-id:to:subject:in-reply-to:references:mime-version :content-transfer-encoding; bh=0uZ85lAgODA4tgjBQ/jAWkd6cb64JWQxBOY67elqow0=; b=mqXAxPhDMLJthMqL1kNwlV4o+v6txxXa9Cpxr5ewEXme1bg8TTFVvAB8vp2707UIDZ aiocbY1bc9MtOIrtsQdjrnOJEZJz3TRZpij+wGdIc54XDCft0HJ66CcEz2rnm2CsGpxE 7FcvrnmJIrmLgslwI3kogAyVdCp1391yCvj6nnCRya8xeY78hVksLJO1NwmPVpjJQufO yDV8MYgaMIqpxOQWKI8mdELftV1JSNThGLrgQyJBP+45zW/jpg1JSmnQNqtyM0DE9Ynv 2LoysqPz7SBeSGEV87e3KiD/wJQMCNZrr8XriIqz6OIE7KnznZ/aL2W0S4nSUVFhNZ12 94Ag==
In-reply-to: <CAA8k23SHoZGQPSH-tDGE0UhNi4-H3Ky3AKmQyZrE+S0JNf_v3Q@mail.gmail.com>
References: <[email protected]> <[email protected]> <[email protected]> <CAA8k23SHoZGQPSH-tDGE0UhNi4-H3Ky3AKmQyZrE+S0JNf_v3Q@mail.gmail.com>
Reply-to: [email protected]
Sender: [email protected]

Hello Andy,

OK,  understood,  I did some calculations then checked them against an
on-line  calculator and get figures of 68K and 12K for the divider. If I
retained  the existing 15K to ground I might be able to use 82k as the
other  half?  Or  are  these  values too high for needed current flow?
Thanks.    This reply mistakenly went to you by direct e-mail as well,
my mail client needs the Reply To: changing on this forum each time to
go to the whole group, not sure why, sorry...

Monday, January 1, 2018, 10:40:59 PM, you wrote:

> When I said bias half way, meant half way between the two logic
> threshold limits.  Ie mid way between 1.3V (upper limit of
> guaranteed '0' and 2.4V (lower limit of guaranteed '1')  so bias at 1.8V


> Not half the supply volts.


> Study the data sheets and calculate.  Don't just play with components 
> willy-nilly.


> Andy  G4JNT






-- 
Best regards,
 Chris                            mailto:[email protected]



<Prev in Thread] Current Thread [Next in Thread>