Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

LF: Re: MF/160

To: <[email protected]>
Subject: LF: Re: MF/160
From: <[email protected]>
Date: Tue, 24 Oct 2017 13:59:59 +0100
Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=ntlworld.com; s=meg.feb2017; t=1508849999; bh=y7HgMoimV6R0SymiNeOWiKY2sK44tZrYp0tS75R0pSs=; h=From:To:References:In-Reply-To:Subject:Date; b=BU0UX6cfUPR2sZiENDrBvQ5nuzN4Fk/cqBjrg5Ieb/QDx2CjIpUziY9PPiAewh4xi CUjmci+HKuHJj4AInhfzw7dai9vYf2UHvnyHBsYzRGZhYhfuJ/cobsJBlj4ZmQ7M5d 3/5Skxlq5QDTwrknYfu06y7g5SsnuqV+mDKyvdYarLQsHTbzvvfnF0UOkFkO/XI/Yx qbT9TOgX2lj3fgSNdOebYVOcCW65Y2t55IRyRrm49IWMkixlCVEw9t2+DfBa8kgdOe vs7FvBFrjs71g+5/hpH212SGrZKLYJFUwhMZYe5OgbiAjIMLN/KjeC/6lZElDICdE3 rzy4QghLsVEMw==
Importance: Normal
In-reply-to: <CAA8k23QWL=UhuVBqB8S6nnF2bbhO2PoT-UN3eSnhxEwiyDCRPw@mail.gmail.com>
References: <[email protected]> <CAA8k23Q5V3OQcE6E1pAT0ZNuADgahJZ5HhE7BfHBX5pgR0j+vQ@mail.gmail.com> <[email protected]> <CAA8k23TjLUHt6MAT0Zgi6obi0eYti7736s0jy8iX7pkMyOx2yA@mail.gmail.com> <[email protected]> <CAA8k23QWL=UhuVBqB8S6nnF2bbhO2PoT-UN3eSnhxEwiyDCRPw@mail.gmail.com>
Reply-to: [email protected]
Sender: [email protected]
Hi Andy
 
I, like you use SMPSU’s 50V approx 10A . Mine are Chinese albeit shipped in the UK! was a bit dirty but all it needed was a mains input filter. Now very quiet. Wonder what type/model/EBay number you are using. I went for a pair of 28V 10A units so I could use 56 or 28 V on the 472 KHz TX.
 
Thanks
73 Ian G4GIR
 
 
Whic
 
Sent: Monday, October 23, 2017 8:20 PM
Subject: Re: Re: Re: LF: MF/160
 
I don't knoe why radio amateurs are so anti SMPSU on principle.   
Unfiltered nasty Chinese ones may be bad, but anything can be cleaned up. 
 
My 50 Volt 20A one I use with teh 475kHz PA is absolutely quiet, not a whisper detectable on any frequency from LF to HF
 
'jnt
 
 
On 23 October 2017 at 20:07, dhchurch <[email protected]> wrote:
Hello Andy
 
The idea of using any SMPS in, or near, the shack is somewhat abhorrent. It is possible to introduce a series circuit in a linear PSU which is not exactly a regulator but has a hum cancellation circuit, something that used to appear in an ancient National Semiconductor publication. I'd love to try it but just haven't left any room in my PSUs, they're stuffed full, including a cooling fan. A couple of 100Hz side bands are at least predictable, my PA has,  but there is one regular transmission on LF which has all manner of spurii making reception here somewhat variable.
 
I think Dave, GW8GLO, has a system which promptly knocks off his transmitter SMPS when going into Rx mode, maybe this is the way to go.
 
73, Hugh, M0DSZ
 
----- Receiving the following content -----
Receiver: rsgb_lf_group
Time: 2017-10-23, 10:12:17
Subject: Re: Re: LF: MF/160
 
Its a difficult call - I have a similar problem with my 700 Watt 137kHz Tx.   30dB hum sidebands corresponds to 3% ripple, which in the main scheme of things is not that much.   It would need an enormous reservoir capacitor to make a serious reduction.  
 
Either that or design the Tx to run from 50V and use a SMPSU instead of raw rectified AC
 
Andy  G4JNT
 
On 23 October 2017 at 10:03, dhchurch <[email protected]> wrote:
Mal, I think a little attention should be paid to, perhaps, your power supply. The 100Hz sidebands, as I recall from earlier this week, should be much lower in level. Seen on Spectrum Lab at one stage, they were less than -30dB in comparative level. 
 
73, Hugh, M0DSZ
 
----- Receiving the following content -----
Receiver: rsgb_lf_group
Time: 2017-10-22, 22:44:59
Subject: Re: LF: MF/160
 
You're so strong, Mal,  I'm getting decodes on your hum sidebands
 
21:36  G3KEV  0.475804  -27  0  IO94sh  5  G4JNT  IO90iv  384  189  2017-10-22 21:36  G3KEV  0.475704  +3  0  IO94sh  5  G4JNT  IO90iv  384  189  2017-10-22 21:36  G3KEV  0.475604  -29  0  IO94sh  5  G4JNT  IO90iv  384  189  2017-10-22 1
 
Andy   G4JNT
 
On 22 October 2017 at 19:25, mal hamilton <[email protected]> wrote:

NICE CONDX 160M THIS EVENING VK7DIK  REPORTING G3KEV WSPR MODE

LOOKING GOOD FOR MF/630 M ALSO

TNX REPORT DE MAL/G3KEV

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Sent from Mail for Windows 10

 

 
 
 
<Prev in Thread] Current Thread [Next in Thread>