|
Hi Stefan yes I think you are right the attachment
size in included in the message size. I thought that was Riccardo's problem. If
the attachment is being stripped off, but the email passed, then I think
this might be occurring somewhere on route. At one time my ISP did not allow
attachments above 1.5MB to be sent to any destination, though I could
receive 20MB. This was a pain with papers, collaborative work, and equipment
manuals.
----- Original Message -----
Sent: Friday, July 07, 2017 12:29
PM
Subject: Re: LF: Simple coherent
frequency generator
Strange, normally when the attachment size becomes higher than
about 350 kB, the complete mail is rejected, not only the attachment. So maybe
the reason is somewhere else.
73, Stefan
Am 07.07.2017 13:05,
schrieb Alan Melia:
Hi Riccardo, I will forward attachments but
there is a size restriction (I can't no remember what it is but probably
about 3 to 500kB) This one is an old text distributors, from the days
of dial-up :-))
It will just dump oversize
messages.
Alan
G3NYK
-----
Original Message -----
Sent:
Friday, July 07, 2017 11:44 AM
Subject:
Re: LF: Simple coherent frequency generator
Hi Markus, LF
Sorry but I have got some problems with the reflector (no
forwarding with attachements).
Link to schematics:
https://www.dropbox.com/sh/65l7vehoy96yon8/AABYdfyf5HkpdMVbDEI-TXbYa?dl=0
Yes, Markus. In David's PA the modulator (two XOR ports,
SCH2) it's inserted between D Flip Flop and MOS drive. The phase changes
are audible on output transformer during TX (like tic-tic-tic...), but it
works very well.
We haven't tested NEO-6 modules, but i think NEO-M8N/Q is
the better choice (in particular for the TCXO on board and improved GPS RX
sensitivity).
All the best
|
|
