Hello Clemens,

No it's assembled like this:

2  X  amps to combiner via 2 off 12 inches Teflon coax cables : Combiner
to  LPF via 12 inches Teflon co-ax : Combiner to outside about 40 feet
RG-213  co-ax  :  Outside  is impedance matching transformer on top of
loading  coil / variometer : Impedance matching transformer to loading
coil  via  12  inches  RG-213 : Loading coil feeds vertical section of
antenna directly. Thanks

Saturday, June 24, 2017, 6:36:00 PM, you wrote:

> Hi Chris, 

> Just to be sure, you
>>want  me  to  reverse  the  connections  so  the AIM is looking at the
>>winding  that  would  normally go to the loading coil, and the loading
>>coil  and  antenna is connected to the winding that would normally go,
>>via about 50 feet of co-ax, to the auto transformer in the shack bound
>>combiner?

> I'm not sure if I understand your description correctly so I try with a block 
> diagram.
> Is it like this?
> TRX - short coax - autotransformer - longer run of RG-213 -
> isolation XFM 1:1 - loading coil - feeder - antenna

> 73
> Clemens
> DL4RAJ 







-- 
Best regards,
 Chris                            mailto:[email protected]