Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

Re: LF: TXing on VLF again, Iron powder cores... broomstick coil?

To: [email protected]
Subject: Re: LF: TXing on VLF again, Iron powder cores... broomstick coil?
From: Markus Vester <[email protected]>
Date: Tue, 19 Apr 2016 13:37:45 -0400
Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=mx.aol.com; s=20150623; t=1461087467; bh=+2cEH2RWt5qVv+JDKgqTHr70eXt0aSM5zQoSwJn1VLs=; h=From:To:Subject:Message-Id:Date:MIME-Version:Content-Type; b=eEJn4a5J2qRAe/FLM0nhCdyBAjkv3vKd5GATEl2f6mo/PpIn0CjMbn+UZM9coSWzu a3P5S7l5MojgTeWBhDZXXr8R0sRmZ19OkN6DHKlhSHuBNO62xrQQu6h4ISMdR81QyN KZoOnLjm4um+n9/7DepDr95e+07vd6cLUbyiJiQY=
Reply-to: [email protected]
Sender: [email protected]
Peter, thanks for that. Scaling AL and height indicates µr ~ 700 which probably means ferrite material. With a one meter stack of those cores it would be easy to reach the desired inductance, but flux density and achievable voltage might be limited by saturation and hysteresis losses. I will take a look when the cores arrive here.
 
Best 73,
Markus (DF6NM)
 
 
PS there was a minor error in mycalculation of the µd term: 1 m^2 / 4cm^2 = 2500, not 5000.


-----Ursprüngliche Mitteilung-----
Von: Peter <[email protected]>
An: rsgb_lf_group <[email protected]>
Verschickt: Di, 19 Apr 2016 4:48 pm
Betreff: Re: LF: TXing on VLF again, Iron powder cores... broomstick coil?




Hi Markus et al. 

On 17.04.2016 13:56, Markus Vester wrote:
> ...
> Anyway I have ordered some cores to make measurements, and also some of the
> red double-height ferrite (?) sleeves from the same supplier.

Measured both at 10kHz.

Toroids, green/blue : 91 nH/n²
Sleeves, red : 4406 nH/n²

73 de df3lp,
Peter



<Prev in Thread] Current Thread [Next in Thread>