Re: LF: U3S on JT-9

[Vincent Stallbaum <info@vsas.de>]

Hi All,

a Pic or Atmel for pressing left and right buttons in the correct sequence could do the job within milli seconds.

But too mutch action for me. A special JT9 firmware would be great. A pitty that the code isn't open source. 

73
Vinny



Am 04.02.2016 10:14, schrieb VIGILANT Luis Fernández:

Hi Steve, Vinny

 

I'm also using U3 as MF exciter. Thought about using it on JT9 as I have a U3S also (JT9 only supported in U3S not U3)

But, as Vinny reports, it would be a nightmare to struggle with menus to change the message :(

 

An U3S with UART and some commands (CAT command based maybe) would be nice. But obviously a different beast

Probably the U3S Arduino shield is the way to go for such a thing

 

73 de Luis 

EA5DOM

---

De: owner-rsgb_lf_group@blacksheep.org [mailto:owner-rsgb_lf_group@blacksheep.org] En nombre de Vincent Stallbaum
Enviado el: jueves, 04 de febrero de 2016 8:02
Para: rsgb_lf_group@blacksheep.org
Asunto: AW: LF: U3S on JT-9

Hello Steve,

I have tried to use mine for a driver during OZ0IL activity. RX was a funcube pro +.

The generated signal is ufb. I got many decodes. 

But changing the messages in 10 seconds after RX decode is nearly impossible because of the menue handling. Especially entering the partners callsign takes too long.

So best solution would be to use two U3S to prepare the next message on the second one. It's worth money.

vy73 de Vinny, DL6II

-------- Ursprüngliche Nachricht --------
Von: Steve <VE7SL@shaw.ca>
Datum: 04.02.2016 01:27 (GMT+01:00)
An: rsgb_lf_group@blacksheep.org
Betreff: LF: U3S on JT-9

Have any of you been using this for JT-9 QSO work on 630m, either by itself
or for a driver?


Steve




WEB - "The VE7SL Radio Notebook":  http://members.shaw.ca/ve7sl

VE7SL BLOG - "Homebrewing and Operating Adventures From 2200m to Nanowaves":
http://ve7sl.blogspot.ca/