Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

Re: VLF: 8819.9 Hz in Virginia?

To: <[email protected]>
Subject: Re: VLF: 8819.9 Hz in Virginia?
From: "Markus Vester" <[email protected]>
Date: Fri, 12 Dec 2014 17:12:04 +0100
Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=mx.aol.com; s=20140625; t=1418400730; bh=wB5MuyvraGEiTIXy6CO5795CfAJiQun1fDWlrAnJhHE=; h=From:To:Subject:Message-ID:Date:MIME-Version:Content-Type; b=wL7o+ygxwVaskRQkKn0o1RvViFksS3GacsJ6E8/zjW+X9IFiK9IhVXWilCwXxry6m nd7lNmQ9EbP49WVh1DAVnzXvFv9P+7/v8o+evYv75XAf7ZJ0D73PrnE3SwMO26PmEZ grXQiSOUmDfRYxRgPjVXcueSbW0tN6A+hRKqFR/A=
Importance: Normal
References: <[email protected]> <[email protected]> <[email protected]> <[email protected]> <[email protected]>
Reply-to: [email protected]
Sender: [email protected]
Hi Jim,
 
>my spectrogram data was captured at ~ 1mHz resolution (715 uHz bin width),
 
Your resolution is actually similar enough to Paul's 833 uHz bins, and the excursion on the unid signal (around 0.010 Hz, not uHz) would be clearly visible. Could you post your spectrogram around 16 UT yesterday?
 
Best 73,
Markus

Sent: Friday, December 12, 2014 4:17 PM
Subject: RE: VLF: 8819.9 Hz in Virginia?

Paul,

I've been monitoring near 8820 since Dex's prior transmission (assessing and
mitigating noise in case Dex switches on again). I don't have good
absolute-frequency calibration at this northern Virginia location, and I'm
interested in whether the signal captured at Forest (near 8819.9) is the
same signal that I have seen almost continuously for the past 6 days (I have
seen occasional small frequency shifts that do not seem like utility power
line frequency shifts). I tried to correlate the ~0.01Hz delta-f feature
shown in your spectrogram link (below), between 1400 UTC and 1700 UTC, with
my local spectrogram. This raised a Spectrum Lab question: my spectrogram
data was captured at ~ 1mHz resolution (715 uHz bin width), and accordingly
I can't quite discern 0.01uHz features (like the one shown in your Forest
link) in my waterfall display. Can I inspect previously captured Spectrum
Lab data at higher resolution by accessing a data file, or perhaps by
opening a new waterfall-display window? Apologies for bothering you with
this detail-level question; I wanted to try to correlate my data with the
data in your link below while the data is still in my Spectrum Lab buffer,
and without corrupting or erasing the data in the attempt to inspect it at
higher resolution.

73,

Jim AA5BW  

-----Original Message-----
From:
[email protected]
[mailto:[email protected]] On Behalf Of Paul Nicholson
Sent: Friday, December 12, 2014 3:25 AM
To:
[email protected]
Subject: Re: VLF: 8819.9 Hz in Virginia?

Spectrogram covering 24 hours yesterday

 
http://abelian.org/vlf/tmp/141211c.gif

A wandering signal from a crystal source of average stability.
These are fairly common when you dig deep enough into the noise.
Fortunately easy to distinguish from a GPS locked amateur signal.

Demonstrates how useless an undisciplined xtal osc is for VLF (tx and rx).

--
Paul Nicholson
--


<Prev in Thread] Current Thread [Next in Thread>