Alan/Jack/Stefan/Steve and all - thanks for the feedback, and as
described its all a matter of compromise but the new vertical structure
FET Mesh designs seem to be reasonable with similar the lower R on ohm figures
of the older devices - rise and fall times/input cap and gate charge all look
dooable - just the dollar amount...
Just for info - Ive taken the
plunge and ordered
STW70N60M2
600V VDs 0.031 Ohm on and Imax as 68A - Ill let you know how
they work in cct but it looks like completely over the top Gold over
engineered FET device but I need the insurance give the changes and sudden
animal interventions/weather I get up here in Alaska - http://www.mouser.com/ProductDetail/STMicroelectronics/STW70N60M2/?qs=Rlwi1sSxVL4hmaII3E%2FvIA%3D%3D I
temp switched over to a 600V FET, the end of life or about to be http://www.mouser.com/ProductDetail/STMicroelectronics/STW16N65M5/?qs=sGAEpiMZZMutXGli8Ay4kNbVQor0Njej2JFFy%252bQzHzg%3d this
is a "smaller" I tot device and gets a little warmer than more lower Ron ohms
34NB20 but was running fine in 1Kw W1VD design with no change in tap points
out optimizing the Voltage/Current ratios.... I have a pair of them at 300W
out and effieciency was about 72% or so. I didnt see any peaky waveform on the
drains either.. All
being well Ill be on WSPR2 630m tonight - weather up here is far too warm -
lake ice has melted and the ducks and Swans are back enroute
South Laurence
KL7L
From:
[email protected]To:
[email protected]Date: Fri, 10
Oct 2014 19:03:39 -0700
Subject: LF: Re: : Re: STW34NB20 - used in a number
of MF and LF PA designs
Hi Laurence
There is no easy answer to that problem. If
there were some way you could reduce the time it takes to shut down the final
using a faster circuit, it would reduce the chance of smoked FETs
obviously. I guess it's the high winds that really cause the biggest
problem there. The close proximity of our trees here limit me from leaving the
amp unattended during winds.
