|
Hi Gary, as far as I
remember wspr-x doesn't like path names containing spaces, like ...\amateur
radio\... This will produce an error when the decoder tries to access
the .c2 file containing the downconverted audio.
I can only speclate about the non-decodes
thereafter. You might want to check the samplerate at nominal 12000
samples/second. In case it's off by more than half a percent or so the ability
to decode will be affected.
Best 73,
Markus (DF6NM)
Sent: Friday, January 25, 2013 3:48 PM
Subject: LF: WSPRX no decode
Hi All,
Yesterday I downloaded & installed WSPRX into a
folder of my choice <C:\amateur radio\wsprx>
When testing on Stefan's 136 kHz WSPRX-15 last
night I got no decodes but at the end of the 15 min period I got an error
message about a path could not be found.
So after deleting that today I downloaded &
installed using the default path of the install software.
Now I do not get the error message but still no
decodes.
I am assuming that the signals around 475.700 kHz
are WSPR (from about 1500z) & PC clock is accurate so if they are why no
decodes ?
73,
Gary - G4WGT.
| 