Hi
Markus
Thanks
for the advice ? modified s/w in use.
I
have copied you both but spots are not being uploaded to WSPRnet ? the upload
box is checked and it is normally OK.
1608
-6 0.8 0.137427 0 DK7FC JN49 30
1618
-18 0.3 0.137467 0 DF6NM JN59 27
73
Terry
it
looks like the frequencies don't match yet. SndInput fc should be the
incoming audio band from the RX, and SndOutput fc should correspond to the BFO
frequency in WSPR. The fc value can be edited in the little SndInput / SndOutput
windows so you won't have to restart the batch script.
Stefan
and I are currently sending WSPR-8 on 137430 / 137440 Hz in alternate 10 minute
slots. Thus with your 136 kHz LO, you could set fc = 1430 in SndInput. As
your WSPR is listening around 2 kHz, SndOutpt needs to have fc =
2000. If you would like to show the correct frequency for Stefan in the
spots, you can set the dial entry in WSPR (but not your RX!)
to 0.13543 MHz.
BTW
I have uploaded a modified version today which starts the replay immediately
after the incoming signal has ended. So the spots will be delayed by 8 instead
of 10 minutes. There are also some amendmends in the readme.
