Jan,
I have been able to copy DI2AN WSPR without any problem.
Just make sure that DI2AM (who just 50Hz up from DI2AN but about 20dB stronger)
does not trigger the AGC of your RX. Best is to disable the AGC. Otherwise
reduce the RF gain until the s-meter does not move any more (in most cases the
s-meter signal is used to drive the AGC). A third methid (if you acnnot reduce
RF gain) is to add an attenuator between ant and RX (again until there is no
s-meter movement).
73, Rik ON7YD - OR7T
________________________________________
Van: [email protected] [[email protected]]
namens pa3abk [[email protected]]
Verzonden: maandag 29 november 2010 0:32
Aan: [email protected]
Onderwerp: Re: LF: MF_Beacon DI2AF is running in WSPR_Mode
Pfff what a mess..
Finally decoded... (Most of the others did it also...)
2302 -18 0.9 0.505147 -1 DI2AF JN59 13
Could see you in SpecLab but unable to decode.
QRN 3/4 ere. And those other DL beacons are really pushy.
You'r the only 600m WSPR qrv so will keep it running overnite
Paul (OH1LSQ) what's your secret. assume qrm-free location :-)
GN
Jan/pa3abk
28-11-2010 20:57, Beckmann, Gerhard :
>
> Hello LF / MF
>
> MF-Beacon DI2AF is QRV again in WSPR-Mode on 505.13 kHz (Dial 503.63 kHz).
>
> Reports are welcome! >> TU!
>
> best 73 de Gerhard / DK6NI (JN59LN)
>
|