Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

RE: LF: ros -MF 502 K -on now-

from [Rik Strobbe] [Permanent Link][Original]
To: "[email protected]" <[email protected]>
Subject: RE: LF: ros -MF 502 K -on now-
From: Rik Strobbe <[email protected]>
Date: Sat, 28 Aug 2010 22:23:59 +0200
Accept-language: nl-NL, nl-BE
Acceptlanguage: nl-NL, nl-BE
In-reply-to: <[email protected]>
References: <1741DFA12A93497498225EEE675D5806@AGB> <6392A70598D241C9AC1D1866781D77EE@AGB> <1A65325BA9324EFFA87C0119552B2B48@AGB> <009d01cb46da$38fcfd70$0401a8c0@xphd97xgq27nyf>,<[email protected]>
Reply-to: [email protected]
Sender: [email protected]
Thread-index: ActG5lPXHr2YLOqMQeeBdj5tYQHaGQACJ5mm
Thread-topic: LF: ros -MF 502 K -on now-
Gary,
 
I had a good visual signal, but no decode. I'll try to figure out what is wrong.
 
73, Rik  ON7YD - OR7T
 
Van: [email protected] [[email protected]] namens Gary - G4WGT [[email protected]]
Verzonden: zaterdag 28 augustus 2010 21:15
Aan: [email protected]
Onderwerp: Re: LF: ros -MF 502 K -on now-

OK LF,

Ready to run CMSK8 again at 100mW ERP.

502kHz USB dial freq Tx at 1500Hz.

73

Gary - G4WGT.



On 28 August 2010 18:55, mal hamilton <[email protected]> wrote:
Graham
Nice QRO station, good copy, show the QRP merchants how it should be done.
g3kev
 
----- Original Message -----
From: Graham
Sent: Saturday, August 28, 2010 5:37 PM
Subject: Re: LF: ros -MF 502 K -on now-

Power  110 watts
rx  502 khz usb -on-
beacon in auto report mode
tx mf-1
 
Rpt welcome , G .

From: Graham
Sent: Saturday, August 28, 2010 3:00 PM
Subject: Re: LF: ros -MF 502 K -on now-

couple of glitches
 
back  at 1457 local  100 watts mf-1
 
rx  502 usb  -ON-

From: Graham
Sent: Saturday, August 28, 2010 12:42 PM
Subject: LF: ros -MF 502 K -on now-

Running  ROS -MF-1 beacon
tx/rx 502 K usb
rx - 502 K
beacon in auto  reply  
 
50 watts  to Ae
 
tnx Gary  for auto  spot







[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: LF: ros -MF 502 K -on now-, Gary - G4WGT
Next by Date:  Re: VLF: Re: Transmitting 250W at 8970 Hz on a 600m spaced earth antenna, Stefan Schäfer
Previous by Thread:  Re: LF: ros -MF 502 K -on now-, Gary - G4WGT
Next by Thread:  Re: LF: ros -MF 502 K -on now-, Martin Evans
Indexes:  [Date] [Thread] [Top] [All Lists]